Home » HP Manuals » Storage Devices » HP StorageWorks 2/16V » Manual Viewer

HP StorageWorks 2/16V HP StorageWorks SAN Switch Rack Mount Kit Installation I - Page 19

Tighten the hex nuts installed in, on See, This completes the rack mount procedure., step 4

View all HP StorageWorks 2/16V manuals

Add to My Manuals
Save this manual to your list of manuals

Page 19 highlights

Figure 10: Securing the Device (in an HP System/e rack) 3. Tighten the hex nuts installed in step 4 on page 10. See Figure 3. Note: To uninstall a device, remove the middle #10-32 x 1/2-inch Phillips pan head screw with captive star lock washer from either side of the rack uprights. This completes the rack mount procedure. SAN Switch rack mount kit installation instructions 19

Section	Page
About this Document	3
Supported Devices	3
Supported HP Custom Racks	3
Related Documentation	4
Before You Begin - Important Information about the Plenum	4
Installation and Safety Guidelines	5
Using the SAN Switch Rack Mount Kit to Install an HP StorageWorks Device	6
Required Tools and Hardware	6
Table 1: Hardware included in the SAN Switch Rack Mount Kit	6
Figure 1: Installing the Rear Mounting Brackets (HP 10000 Series Racks)	8
Figure 2: Installing the Rear Mounting Brackets (HP System/e Rack)	9
Figure 3: Installing the Outer Rails (HP 10000 Series Racks)	10
Figure 4: Assembling the Outer Rails (HP 10000 Series Racks)	11
Figure 5: Assembling the Outer Rails (HP System/e Rack)	12
Table 2: Number of Screws Required to Secure the Inner Rails	13
Figure 6: Attaching the Inner Rails to an MP Router	15
Figure 7: Attaching the Inner Rails to a 4/64 SAN Switch	15
Installing the Plenum (if required)	17
Figure 8: Attaching the Plenum to a 4/8 or 4/16 SAN Switch	17
Securing the Device to the Outer Rails	18
Figure 9: Securing the Device (in HP 9000 Series or HP 10000 Series Racks)	18