Home » HP Manuals » Storage Devices » HP StorageWorks 2/16V » Manual Viewer

HP StorageWorks 2/16V HP StorageWorks SAN Switch Rack Mount Kit Installation I - Page 12

Assembling the Outer Rails (HP System/e Rack)

View all HP StorageWorks 2/16V manuals

Add to My Manuals
Save this manual to your list of manuals

Page 12 highlights

- For an HP System/e rack, install two #10-32 x 1/2-inch Phillips pan-head screws with captive star lock washers and two #10 alignment washers in the upper and lower hole locations of the right rail. Then install two #10-32 x 1/2-inch Phillips pan-head screws with captive star lock washers and two #10 alignment washers in the upper and lower hole locations of the left rail, as shown in Figure 5. Figure 5: Assembling the Outer Rails (HP System/e Rack) 12 SAN Switch rack mount kit installation instructions

Section	Page
About this Document	3
Supported Devices	3
Supported HP Custom Racks	3
Related Documentation	4
Before You Begin - Important Information about the Plenum	4
Installation and Safety Guidelines	5
Using the SAN Switch Rack Mount Kit to Install an HP StorageWorks Device	6
Required Tools and Hardware	6
Table 1: Hardware included in the SAN Switch Rack Mount Kit	6
Figure 1: Installing the Rear Mounting Brackets (HP 10000 Series Racks)	8
Figure 2: Installing the Rear Mounting Brackets (HP System/e Rack)	9
Figure 3: Installing the Outer Rails (HP 10000 Series Racks)	10
Figure 4: Assembling the Outer Rails (HP 10000 Series Racks)	11
Figure 5: Assembling the Outer Rails (HP System/e Rack)	12
Table 2: Number of Screws Required to Secure the Inner Rails	13
Figure 6: Attaching the Inner Rails to an MP Router	15
Figure 7: Attaching the Inner Rails to a 4/64 SAN Switch	15
Installing the Plenum (if required)	17
Figure 8: Attaching the Plenum to a 4/8 or 4/16 SAN Switch	17
Securing the Device to the Outer Rails	18
Figure 9: Securing the Device (in HP 9000 Series or HP 10000 Series Racks)	18