HP StorageWorks 2/32 SAN switch 2/32, version 4.0.2b release notes - Page 10

SAN Switch 2/32 Firmware Version 4.0.2b Updates Fabric OS Command Changes The following lists new or modified commands added to the Fabric OS Version 4.0.2b: • killtelnet command • loopporttest command • portcfgdelayflogi command • supportshow command • portcfglongdistance command • portcfgshow command • ifmodeset command NOTE: For more information about these commands, refer to the hp StorageWorks Fabric OS Version 3.0.x/4.0.x Reference Manual. portcfglongdistance Command Summary Extended links in the same SAN are either 1Gb or 2Gb, but not both. If you have 1 Gb extended links in the the SAN you can not add a 2Gb Extended Link to the same SAN. Enhancement A new parameter was added to this command. The new syntax is as follows: portCfgLongDistance [slot/]port[, distance_level][, linkinitmode] linkinitmode Operand The linlinitmode operand applies to long distance setup only. It does not affect a normal link. It is added to ensure the long distance link initialization sequence. It is not required for long distance, but may be useful when initiating L1 and L2 links. linkinitmode Usage Specify 1 to activate a long distance link initialization sequence. Specify 0 to deactivate this mode. The default value is 0 (disabled). This operand is optional. The following example is for a 100km link on a port in a V4.0 switch with long distance link initialization protocol enabled: switch:admin> portCfgLongDistance 2/3 L2 1 done. 10 SAN switch 2/32, version 4.0.2b release notes