HP StorageWorks 8/80 HP StorageWorks Fabric OS 6.2.0e release notes (5697-0354 - Page 36
HP StorageWorks 4/256 SAN Director CP reboots due to the Software
View all HP StorageWorks 8/80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Bogus core_file created and transferred after the first reboot after a firmwaredownload. Fixed in Fabric OS 6.2.0. B-series Multi-protocol (MP) Router blades in HP StorageWorks DC SAN Backbone Director chassis may fail sysverification tests. Fixed in Fabric OS 6.2.0. Workaround prior to upgrade: Rerun system verification. With a switch in Interop Mode 2 or 3, the Zoning configuration is not being included in configupload. Fixed in Fabric OS 6.2.0. FICON Channel continuously sends RRQ frames for approximately 20 seconds before aborting. Fixed in Fabric OS 6.2.0. If QoS and Diff Serv are enabled, some FCIP tunnels may not come online in the case of an 8 to 1 fan-in scenario. Fixed in Fabric OS 6.2.0. Workaround prior to upgrade: Port disable/enable the VE-Port Under rare conditions, fabric mode TopTalker monitor does not display correct flow values. Fixed in Fabric OS 6.2.0. Attempting to configure port mirroring on a director with both 4Gb and 8Gb blades may result in a software Verify error. Fixed in Fabric OS 6.2.0. In rare instances the Name Server DB is out of sync between FOS and EOS switches in interop mode 3. Fixed in Fabric OS 6.2.0. Workaround prior to upgrade: After locating the device ID, disable and then enable that device. Seccertutil show does not display the contents of certificates with .cer extension. Fixed in Fabric OS 6.2.0. Workaround prior to upgrade: Only LDAP certificates with .cer extension is supported; so use the --ldapcert option for importing .cer certificates. When resetting all the hosts on a blade or slotpoweroff on a blade, HP StorageWorks 4/256 SAN Director CP reboots due to the Software Watchdog detecting unexpected termination of the Name Server daemon. Fixed in Fabric OS 6.2.0. Fastboot causes unnecessary FFDC, ERROR, ..., libipadm: em_AdmSwitchNameGet() Fixed in Fabric OS 6.2.0. In some instances of congestion in the Ethernet network, the displayed VE port utilization value is incorrect. Fixed in Fabric OS 6.2.0. Workaround prior to upgrade: Use portperfshow command. Reject code '0B' response to a QSA frame causes channel definition errors. Fixed in Fabric OS 6.2.0. Workaround prior to upgrade: Block off a badly misbehaving port that is generating bad traffic on a switch port that is putting a lot of stress on the embedded port. 36