HP StorageWorks 8/80 HP StorageWorks Fabric OS 6.2.0e release notes (5697-0354 - Page 38

The error message is cryptic when the interop fabric contains more than 60 devices in the default zone and the user tries cfgenablecfg- Fixed in Fabric OS 6.2.0. disable. When disabling/enabling a port, port fencing disables the port because the allowable number of invalid transmission words is exceeded. Fixed in Fabric OS 6.2.0. Ag --show on an HP StorageWorks 8/8 or 8/24 SAN Switch shows incorrect edge switch IP address after a slave port is swapped with an N-port outside of the trunk group. Fixed in Fabric OS 6.2.0. Workaround prior to upgrade: Reboot the switch and ag --show cli will show the correct output. The 32-character switchname and chassisname extensions do not fully display in RASLog outputs, such as errdump or supportsave output. Fixed in Fabric OS 6.2.0. Workaround prior to upgrade: Use only 16-character switchname and chassisname fields if full name display in the logs is required. FFDC occurs when 16-31 char switch/chassis name is input on a platform that only supports up to 15. Fixed in Fabric OS 6.2.0. I2C response failure and subsequent reset occasionally results in HP StorageWorks DC SAN Backbone Director fan fault errors. Fixed in Fabric OS 6.2.0. Under some conditions N_Port Failover may not work when swapping trunked and non-trunked N_Ports on an Access Gateway. Fixed in Fabric OS 6.2.0. Workaround prior to upgrade: Execute portdisable/portenable of F_Ports or switchdisable/switchenable or reboot the switch. Auto_ELP setting for EX_Port is not restored by configdownload. Fixed in Fabric OS 6.2.0. Workaround prior to upgrade: Use auto_elp mode. When running stressful IRNDUP to CUP tests, user may observe Intermittent Channel Timeouts. Fixed in Fabric OS 6.2.0. Warnings of excessively high temperature seen on some HP StorageWorks 8/40 SAN switches. Fixed in Fabric OS 6.2.0. Workaround prior to upgrade: Increase cooling or relocate switch to cooler location. Be sure switch is installed with proper spacing above and below it. POST (portloopback test) intermittently fails on HP StorageWorks 400 Multi-protocol Router and B-series Multi-protocol Router blade. Fixed in Fabric OS 6.2.0. Workaround prior to upgrade: Rerun diags by rebooting the switch or powering on the slot with B-series Multiprotocol Router blade. Zone Transaction appears to succeed in SMIA when the transaction was aborted by web GUI. Fixed in Fabric OS 6.2.0. Port address from switchshow does not include offset used for Interop mode 2. Fixed in Fabric OS 6.2.0. 38