HP StorageWorks 8/80 HP StorageWorks Fabric OS 6.2.0e release notes (5697-0354 - Page 43
CP card of HP StorageWorks 4/256 SAN Director is set to FAULTY
View all HP StorageWorks 8/80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Channel ack_1 to Control Unit ACC is being F_RJT'd after successful RNID. Fixed in Fabric OS 6.2.0. F_RJT not returned for unroutable class 2 PLOGI. Fixed in Fabric OS 6.2.0. Workaround prior to upgrade: Do not use port 0 for an ISL. Missing CE DE status. Fixed in Fabric OS 6.2.0. FMS does not retry status after FICON channel returns LBY for Device End. Fixed in Fabric OS 6.2.0. FICON CUP reports incorrect Director Size Code in Basic Sense and Sense ID data for HP StorageWorks 8/40 and 8/80 SAN switches. Fixed in Fabric OS 6.2.0. Portcfgspeed command on 8G FC platforms are accepting invalid port speed = 5. Fixed in Fabric OS 6.2.0. Workaround prior to upgrade: Do not provide a value of 5 to the portcfgspeed command. Speed will be set to 8. If that is not desired, re-submit the command with the proper port speed. XRC Emulation allows FICON Disk Control Unit paths to be activated with DPR Mode. Fixed in Fabric OS 6.2.0. FMS stuck busy condition caused host *MASTER* START PENDING upon bringing switch online to mainframe operating system. Fixed in Fabric OS 6.2.0. CP card of HP StorageWorks 4/256 SAN Director is set to FAULTY (51). Fixed in Fabric OS 6.2.0. HP StorageWorks 8/8, 8/24, 8/40, and 8/80 SAN switches: when normal fan activity is interrupted, the high RPM fan rate cycle time Fixed in Fabric OS 6.2.0. takes 1 hour. RLS request from FICON host receives LS_RJT 031F in Interopmode 2. Fixed in Fabric OS 6.2.0. FMS Mode enable failed due to insufficient frame filtering resources on some ports. Fixed in Fabric OS 6.2.0. HP StorageWorks DC SAN Backbone Director blades fault after resetting a server with 32 HBAs. Fixed in Fabric OS 6.2.0. Workaround prior to upgrade: Power cycle the slot. Set port speed to anything other than autonegotiate. Fast Write configuration not properly installed after repeated, back-toback cable pull and re-inserts. Fixed in Fabric OS 6.2.0. Out of Order frames delivered to HP StorageWorks DC SAN Backbone Director via FICON channel from HP StorageWorks 8/40 SAN Switch Fixed in Fabric OS 6.2.0. attached to a storage device (DASD). CAL exception "Non-Secure tunnel can not be configured on the same port as IP sec enabled tunnels." come when trying to configure an IP Fixed in Fabric OS 6.2.0. Sec tunnel on a switch which already had Non secure tunnels in it. HP StorageWorks Fabric OS 6.2.0e release notes 43