HP StorageWorks 8/80 HP StorageWorks Fabric OS 6.2.0g release notes (5697-0035 - Page 34

B-series Multi-protocol Router blade failed to do blade firmwaredownload. Fixed in Fabric OS 6.2.0. Workaround prior to upgrade: Perform slot power off / slot power on the blade that timed out. Switch reboots when IFL is enabled. Fixed in Fabric OS 6.2.0. Frame drop observed after creating a TI zone with failover enabled in the backbone fabric ( TI over FCR). Fixed in Fabric OS 6.2.0. Hard Zoning disabled when ports toggle. Fixed in Fabric OS 6.2.0. Pathinfo doesn't match urouteshow and rtedebug. Fixed in Fabric OS 6.2.0. Sensors show incorrect command output in fully loaded HP StorageWorks DC SAN Backbone Director. Fixed in Fabric OS 6.2.0. Update to VC assignment scheme within core ASIC management structure. Fixed in Fabric OS 6.2.0. Fast Write performance issue with a particular FCIP Ex_Port configuration. Fixed in Fabric OS 6.2.0. Workaround prior to upgrade: Disable FCR routing and Ex_Ports and merge the fabric into one large fabric. Under Port Base Routing, topologyshow always shows None for the In Port field on HP StorageWorks 8/8, 8/24, and 8/40 SAN Switches. Fixed in Fabric OS 6.2.0. Workaround prior to upgrade: Use urouteshow to view the 'Out Port' selected for a particular 'In Port' to a domain when using Port Based Routing. HCL on switch continues if sent Pause frame is rejected by attached M-EOS switch. HCL on switch will sometimes continue, even when a sent Pause frame is rejected by another switch in the fabric. Fixed in Fabric OS 6.2.0. N_Port on Edge_AG_200E_PG got disabled with reason code Initiator/target connected to N-Port. Fixed in Fabric OS 6.2.0. Firmware download of Fabric OS 6.1.0 is allowed on an embedded blade that should not allow it. Fixed in Fabric OS 6.2.0. Fabric Rebuild during HP StorageWorks 8/40 SAN Switch HCL when 1 of 2 Backbones connect to a M6140 director. Fixed in Fabric OS 6.2.0. If Turboramtest is performed, the Telnet console will disconnect. Fixed in Fabric OS 6.2.0. Incorrect error when changed switchname for more than 24 characters through CLI in FMS mode. Fixed in Fabric OS 6.2.0. F_Ports on HP StorageWorks 8/8 and 8/24 SAN Switches AG cannot login, and become G_Ports. Fixed in Fabric OS 6.2.0. Occasionally an LD port gets into a lock up state that causes portGetVCCredits get failed and the ISL segments with LD incomp, although portcfgshow shows both sides of ISL config are the same. Fixed in Fabric OS 6.2.0. Workaround prior to upgrade: Reset with portcfgdefault/portcfgqos. 34