HP StorageWorks 8/80 HP StorageWorks Fabric OS 6.2.0g release notes (5697-0035 - Page 39

Ficud panic and reboot on HP StorageWorks DC SAN Backbone

Get HP StorageWorks 8/80 - SAN Switch PDF manuals and user guides View all HP StorageWorks 8/80 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 39 highlights

Command ipaddrshow does not show the IP address of a blade that is seated in slot 12 of an HP StorageWorks DC SAN Backbone Director. Fixed in Fabric OS 6.2.0. Workaround prior to upgrade: Issue ipaddrshow -slot 12 to get the information. Re-key of LUNs hosted through active/passive ports will not complete if started on the passive path. Fixed in Fabric OS 6.2.0. Wave Length column in port optics dialog is currently blank. Fixed in Fabric OS 6.2.0. Host may lose targets on edge AG in cascaded setup when failover from core-AG to another core-AG connected to different edge fabric switches. Fixed in Fabric OS 6.2.0. Workaround prior to upgrade: Disable/enable the N_Port. Web Tools zoning breaks when third-party storage virtualization appliance changed to standby mode. Fixed in Fabric OS 6.2.0. Workaround prior to upgrade: Change the third-party storage virtualization appliance to standby cf mode. The removal of an encryption performance upgrade license is not prevented. Fixed in Fabric OS 6.2.0. After configuring HP StorageWorks 8/8 or 8/24 SAN Switch AG so that F_Port Trunking works and then performing portdisable on NPorts and then hareboot the 8/8 or 8/24 SAN Switch AG caused unexpected termination of AGD Fixed in Fabric OS 6.2.0. Audit Log [ZONE -3001] not generated when a member is added to TI Zone. Fixed in Fabric OS 6.2.0. The topologyshow command cannot show the "In ports" mapped to "Out port" in port-based routing policy. Fixed in Fabric OS 6.2.0. TCP RX Window advertisement can be much smaller than the actual size of the RX Window. Fixed in Fabric OS 6.2.0. Workaround prior to upgrade: Reduce the committed rate on the FCIP tunnel until the RX window is less than 33 MB. FICON Tape Write Pipelining selectively resets after CmdRetry to No Op Sequence or LBY. Fixed in Fabric OS 6.2.0. Workaround prior to upgrade: Disable FICON Tape Write Pipelining. Ficud panic and reboot on HP StorageWorks DC SAN Backbone Director occurs after executing host command to display the switch. Fixed in Fabric OS 6.2.0. The event description from swEventTraps (related to RLIR events) is not well formatted. Fixed in Fabric OS 6.2.0. Four-node LUN discovery fails if one of the LUN out of 4 LUNs is trespassed. Fixed in Fabric OS 6.2.0. Third-party application paths fails when FC Fast Write is enabled with bi-directional traffic. Fixed in Fabric OS 6.2.0. Java running out of memory in Web Tools. Fixed in Fabric OS 6.2.0. HP StorageWorks Fabric OS 6.2.0g release notes 39

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
Fixed in Fabric OS 6.2.0.
Workaround prior to upgrade:
Issue
ipaddrshow -slot 12
to get
the information.
Command
ipaddrshow
does not show the IP address of a blade that
is seated in slot 12 of an HP StorageWorks DC SAN Backbone Direct-
or.
Fixed in Fabric OS 6.2.0.
Re-key of LUNs hosted through active/passive ports will not complete
if started on the passive path.
Fixed in Fabric OS 6.2.0.
Wave Length column in port optics dialog is currently blank.
Fixed in Fabric OS 6.2.0.
Workaround prior to upgrade:
Disable
/
enable
the N_Port.
Host may lose targets on edge AG in cascaded setup when failover
from core-AG to another core-AG connected to different edge fabric
switches.
Fixed in Fabric OS 6.2.0.
Workaround prior to upgrade:
Change the third-party storage virtual-
ization appliance to standby cf mode.
Web Tools zoning breaks when third-party storage virtualization ap-
pliance changed to standby mode.
Fixed in Fabric OS 6.2.0.
The removal of an encryption performance upgrade license is not
prevented.
Fixed in Fabric OS 6.2.0.
After configuring HP StorageWorks 8/8 or 8/24 SAN Switch AG so
that F_Port Trunking works and then performing
portdisable
on N-
Ports and then
hareboot
the 8/8 or 8/24 SAN Switch AG caused
unexpected termination of AGD
Fixed in Fabric OS 6.2.0.
Audit Log [ZONE -3001] not generated when a member is added to
TI Zone.
Fixed in Fabric OS 6.2.0.
The
topologyshow
command cannot show the "In ports" mapped
to "Out port" in port-based routing policy.
Fixed in Fabric OS 6.2.0.
Workaround prior to upgrade:
Reduce the committed rate on the FCIP
tunnel until the RX window is less than
33 MB.
TCP RX Window advertisement can be much smaller than the actual
size of the RX Window.
Fixed in Fabric OS 6.2.0.
Workaround prior to upgrade:
Disable FICON Tape Write Pipelin-
ing.
FICON Tape Write Pipelining selectively resets after
CmdRetry
to No
Op Sequence or LBY.
Fixed in Fabric OS 6.2.0.
Ficud panic and reboot on HP StorageWorks DC SAN Backbone
Director occurs after executing host command to display the switch.
Fixed in Fabric OS 6.2.0.
The event description from
swEventTraps
(related to RLIR events) is
not well formatted.
Fixed in Fabric OS 6.2.0.
Four-node LUN discovery fails if one of the LUN out of 4 LUNs is tres-
passed.
Fixed in Fabric OS 6.2.0.
Third-party application paths fails when FC Fast Write is enabled with
bi-directional traffic.
Fixed in Fabric OS 6.2.0.
Java running out of memory in Web Tools.
HP StorageWorks Fabric OS 6.2.0g release notes
39