Husqvarna AUTOMOWER 520 Owner Manual - Page 31

3.20.2 Change PIN code Note: Changing the PIN code is not possible if the LED indicator lamp on top of the robotic lawnmower is either red (error) or green (mowing). 1. Enter the current PIN code. 2. Enter the new PIN code. 3. Confirm by entering the same code again. Make a note of the new PIN code on the designated line in Memo. See Introduction on page 3. 3.20.3 Theft protection In the Theft protection menu it is possible to set the alarm duration and also what events should trigger the alarm. Theft protection Alarm duration Lifted Turned upside down STOP button pressed Time lock 3.20.3.1 Alarm duration There is a possibility to set how long the alarm signal should last. A setting between 1 and 10 minutes is possible. 3.20.3.2 Lifted If the alarm Lifted is enabled, the robotic lawnmower senses changes in the lift sensors, and the alarm goes off. 3.20.3.3 Turned upside down If the alarm Turned upside down is enabled, the robotic lawnmower senses changes in the tilt sensors, and the alarm goes off. 3.20.3.4 STOP button pressed If the alarm "STOP button pressed" is enabled, the alarm goes off if someone presses the STOP button. To avoid alarm, the operator must be within short-range (Bluetooth). Note: After an alarm has been triggered, you must be close by the robotic lawnmower, and clear the alarm in the app by entering the PIN code (only available for short-range Bluetooth connectivity). lawnmower is ready to continue operating. A setting between 1 to 100 days is possible, and the default setting is 30 days. 3.20.4 GeoFence The GeoFence function makes it possible to track the movement of the robotic lawnmower, for example in case of theft. GeoFence GeoFence Before GeoFence can be used, its center point (origin) must be set. This is either done during the first start-up sequence, or in the Security menu. Note: It is only possible to set the center point in GeoFence with short-range connectivity (Bluetooth). Note: The robotic lawnmower must have access to GPS satellites to be able to set a GPS position. If the charging station is placed in a mower house, under a roof or a large tree, try to place the robotic lawnmower out on the lawn. Then try to set GeoFence again. 1. Select Settings > Security > GeoFence in the Automower® Connect app. 2. Enable GeoFence by tapping on the On/Off bar. 3. Save the GeoFence setting. The GeoFence radius is 500 m. 3.20.3.5 Time lock A time lock can be set to decide how many days will pass before the PIN code must be entered. This means that the robotic lawnmower cannot be operated/ controlled without first entering the correct PIN code. When the time limit has passed the robotic lawnmower continues to mow as normal, but the PIN code must be entered before any new commands or settings can be done. When the PIN code is entered, the robotic When putting the robotic lawnmower into storage for a long period, such as during the winter, Husqvarna recommends turning off the main switch. With the GeoFence function activated, you will need the PIN code in order to turn off the robotic lawnmower. Once the main switch has been turned off, the function will stay active for another 12 hours. After that it will not be possible to communicate with the robotic lawnmower and the GeoFence function will not be active. 362 - 002 - 06.02.2018 Installation - 31