Home » Husqvarna Manuals » Lawn Mowers » Husqvarna AUTOMOWER 520 » Manual Viewer

Husqvarna AUTOMOWER 520 Owner Manual - Page 60

EC Declaration of Conformity

View all Husqvarna AUTOMOWER 520 manuals

Add to My Manuals
Save this manual to your list of manuals

Page 60 highlights

10 EC Declaration of Conformity 10.1 EC Declaration of Conformity Husqvarna AB, SE-561 82 Huskvarna, Sweden, tel: +46-36-146500, declares that the Robotic lawnmovers Automower® 520 and Automower® 550 with serial numbers dating 2018 week 4 and onwards (the year and week is clearly stated on the rating plate, followed by the serial number), comply with the requirements of the COUNCIL'S DIRECTIVE: • Directive "relating to machinery" 2006/42/EC. • Particular requirements for robotic battery powered electrical lawnmowers EN 50636-2-107: 2015 • Electromagnetic fields EN 62233: 2008. • Directive on "restriction of use of certain hazardous substances" 2011/65/EU. • Directive "relating to noise emissions from outdoor equipment" 2000/14/EC. See also Technical data on page 57 for information regarding noise emissions and the cutting width. The notified body 0404, RISE SMP Svensk Maskinprovning AB, Box 7035, SE-750 07 Uppsala, Sweden, has issued a report regarding the assessment of conformity according to annex VI to the Council's Directive of May 8, 2000 "relating to noise emissions into the environment" 2000/14/EC. The certificate is numbered: for Automower® 520 (01/901/296) and Automower® 550 (01/901/291): • Directive "relating to radio equipment" 2014/53/EU. The following standards have been applied: • ETSI EN 303 447 Final Draft v1.1.0 (2017-06) • ETSI EN 301 511 v12.5.1 • ETSI EN 300 328 v2.1.1 • Electromagnetic compatibility: • ETSI EN 301 489-1 Draft v2.2.0 • ETSI EN 301 489-52 Draft v1.1.0 • ETSI EN 301 489-17 Draft v3.2.0 • ETSI EN 301 489-19 v2.1.0 Husqvarna, 2018-01-02 Lars Roos Global R&D Director, Electric category (Authorized representative for Husqvarna AB and responsible for technical documentation.) 60 - EC Declaration of Conformity 362 - 002 - 06.02.2018

Section	Page
Contents	2
Introduction	3
Memo	3
Product description	3
Capacity	3
Mowing technique	3
Working method	4
Movement pattern	4
Finding the charging station	4
Search method 1 - Irregular	4
Search method 2 - Follow guide wire	5
Search method 3 - Follow boundary wire	5
Product overview	6
Symbols on the product	7
Safety	8
Safety definitions	8
General safety instructions	8
IMPORTANT. READ CAREFULLY BEFORE USE. KEEP FOR FUTURE REFERENCE	8
Safety instructions for operation	8
Use	8
How to lift and move the robotic lawnmower	9
Maintenance	10
In the event of a thunderstorm	10
Installation	11
Presentation	11
Main components for installation	11
Preparations	11
Installation tools	12
Charging station	12
Best charging station location	12
Connecting the power supply	13
Installing and connecting the charging station	14
Charging the battery	14
Boundary wire	14
Plan where to lay the boundary wire	15
Working area boundaries	15
Boundaries within the working area	16
Secondary areas	17
Passages when mowing	17
Slopes	17
Laying the boundary wire	18
Eyelet for connecting the guide wire	18
Laying the boundary wire in towards the charging station	18
Splicing the boundary wire	19
Connecting the boundary wire	19
Installation of the guide wire	19
Laying and connecting the guide wire	20
Checking the installation	21
Connectivity	21
Automower® Connect	21
Getting started	21
Remote HMI	22
Husqvarna Fleet Services	22
How to start up the robotic lawnmower	22
First start-up sequence	22
Pairing with the Automower® Connect app	23
Guide calibration	23
Control panel	23
START and STOP button	23
The LED indicator lamp on the robotic lawnmower	23
Automower® Connect menu	23
Dashboard	23
Map	24
Map settings	24
Settings - overview	24
Timer	24
Timer suggestions Automower® 520	25
Timer suggestions Automower® 550	26
Edit timer settings	26
Edit current timer settings	26
Add a new timer setting	26
Cutting height	26
Operation	26
Weather timer	26
ECO mode	27
Spiral cutting	27
Installation	27
Finding the charging station	27
Charging station signal	28
Follow boundary wire	28
Follow guide wire	28
Guide > Disable / Enable	28
Lawn coverage	28
GPS assisted navigation	28
Area 1-5	28
Area 1-5 > Enable/disable	28
Area 1-5 > How? and How far?	28
Area 1-5 > How often?	28
Corridor width	29
Corridor width > Boundary	29
Corridor width > Guide	29
Exit angles	29
Exit angles > Sectors	29
Reversing distance	30
Drive past wire	30
Accessories	30
Mower house	30
Ultrasonic	30
General	30
Time & Date	30
Reset to factory settings	30
Security	30
New loop signal	30
Change PIN code	31
Theft protection	31
Alarm duration	31
Lifted	31
Turned upside down	31
STOP button pressed	31
Time lock	31
GeoFence	31
Automower® Connect	32
Overview of the settings structure (1)	33
Overview of the settings structure (2)	34
Overview of the settings structure (3) (Bluetooth short-range connectivity only)	35
Messages	36
My mowers	36
Yard layout examples	36
Open and level area	36
A number of islands and a 35% slope	37
L-shaped garden with a couple of islands and the charging station installed in the narrow area	37
U-shaped garden linked with a narrow passage	37
Unsymmetrical working area with a narrow passage and a number of islands	38
Three areas linked with two narrow passages	38
Large complex area with 3 guide wires	38
A secondary area	39
Operation	40
Main switch	40
Start	40
Operating mode - Start	40
Main area	40
Override timer	40
Secondary area	40
Operating mode - Park	41
Park until further notice	41
Start on next timer	41
Parking duration	41
The charging station's park button	41
Operating mode - Pause	41
Stop	41
Switch off	41
Charge a flat battery	42
Slope control	42
Maintenance	43
Introduction - maintenance	43
Clean the robotic lawnmower	43
Chassis and blade disc	43
Chassis	43
Wheels	43
Body	43
Charging station	43
Replace the blades	43
To replace the blades	44
Battery	44
Winter service	44
Troubleshooting	45
Introduction - troubleshooting	45
Fault messages	45
Information messages	48
LED indicator lamp on the charging station	50
LED indicator lamp on the robotic lawnmower	50
Symptoms	51
Finding breaks in the loop wire	52
Transportation, storage and disposal	55
Transportation	55
Winter storage	55
The robotic lawnmower	55
The charging station	55
After winter storage	55
Environmental information	55
Removal of battery for recycling	55
Technical data	57
Technical data	57
Warranty	59
Guarantee terms	59
EC Declaration of Conformity	60

Match case Limit results 1 per page

10 EC Declaration of Conformity

10.1 EC Declaration of Conformity

Husqvarna AB

, SE-561 82 Huskvarna, Sweden, tel:

+46-36-146500, declares that the Robotic lawnmovers

Automower

520

and

Automower

550

with serial

numbers dating 2018 week 4 and onwards (the year and

week is clearly stated on the rating plate, followed by the

serial number), comply with the requirements of the

COUNCIL’S DIRECTIVE:

•

Directive “relating to machinery”

2006/42/EC

•

Particular requirements for robotic battery

powered electrical lawnmowers

50636-2-107: 2015

•

Electromagnetic fields

EN 62233: 2008

•

Directive on ”restriction of use of certain hazardous

substances”

2011/65/EU

•

Directive “relating to noise emissions from outdoor

equipment”

2000/14/EC

. See also

Technical data on

page 57

for information regarding noise emissions

and the cutting width.

The notified body 0404, RISE SMP Svensk

Maskinprovning AB, Box 7035, SE-750 07 Uppsala,

Sweden, has issued a report regarding the assessment

of conformity according to annex VI to the Council’s

Directive of May 8, 2000 “relating to noise emissions into

the environment” 2000/14/EC. The certificate is

numbered: for Automower

520 (01/901/296) and

Automower

550 (01/901/291):

•

Directive “relating to radio equipment”

2014/53/EU

The following standards have been applied:

•

ETSI EN 303 447

Final Draft v1.1.0 (2017-06)

•

ETSI EN 301 511

v12.5.1

•

ETSI EN 300 328

v2.1.1

•

Electromagnetic compatibility:

•

ETSI EN 301 489-1

Draft v2.2.0

•

ETSI EN 301 489-52

Draft v1.1.0

•

ETSI EN 301 489-17

Draft v3.2.0

•

ETSI EN 301 489-19

v2.1.0

Husqvarna, 2018-01-02

Lars Roos

Global R&D Director, Electric category

(Authorized representative for Husqvarna AB and

responsible for technical documentation.)

- EC Declaration of Conformity

362 - 002 - 06.02.2018