Husqvarna AUTOMOWER 520 Owner Manual - Page 47

Alarm! Mower stop

Page 47 highlights

Message Cause Action Charging station blocked The contact between the charging strips and contact strips may be poor and the robotic lawnmower has made a number of attempts to charge. Put the robotic lawnmower in the charging station and check that the charging strips and contact strips make good contact. An object is obstructing the robotic lawnmow- Remove the object. er. The charging station is tilted or bent. Confirm that the charging station is placed on a fully flat and horizontal ground. The charging station must not be tilted or bent. Stuck in charging sta- There is an object in the way of the robotic tion lawnmower preventing it from leaving the charging station. Remove the object. Upside down The robotic lawnmower is leaning too much or has turned over. Place the robotic lawnmower on a flat, level surface, and start the robotic lawnmower again. Needs manual charg- The robotic lawnmower is set to the Secon- ing dary area operating mode. Place the robotic lawnmower in the charging station. This behaviour is normal and no action is required. Next start hh:mm The timer setting prevents the robotic lawn- Change the timer settings. See Edit timer set- mower from operating. tings on page 26. The clock on the robotic lawnmower is not correct. Set the time. See Timer on page 24. Lifted The lift sensor has been activated as the ro- Free the robotic lawnmower. botic lawnmower has become trapped. Collision sensor prob- The body of the robotic lawnmower can not Check that the body of the robotic lawnmower lem, front/rear move freely around its chassis. can move freely around its chassis. If the problem remains, the message requires action by an authorized service technician. Wheel drive problem, Grass or other object is wrapped around the Clean the wheels and around the wheels. right/left drive wheel. Alarm! Mower stop- The alarm was activated because the mower Adjust the mower security settings in the Se- ped was stopped. curity menu, see Security on page 30. Alarm! Mower lifted The alarm was activated because the mower was lifted. Alarm! Mower tilted The alarm was activated because the mower was tilted. Electronic problem Temporary electronic or software related isLoop sensor problem, sue in the mower. front/rear Restart the mower. If the problem remains, the message requires action by an authorized service technician. Charging system problem Tilt sensor problem Temporary problem Temporary battery problem Battery problem Temporary battery or software related issue in the mower. Restart the mower. Disconnect and reconnect the battery. If the problem remains, the message requires action by an authorized service technician. 362 - 002 - 06.02.2018 Troubleshooting - 47

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64

Message
Cause
Action
Charging station
blocked
The contact between the charging strips and
contact strips may be poor and the robotic
lawnmower has made a number of attempts
to charge.
Put the robotic lawnmower in the charging
station and check that the charging strips and
contact strips make good contact.
An object is obstructing the robotic lawnmow-
er.
Remove the object.
The charging station is tilted or bent.
Confirm that the charging station is placed on
a fully flat and horizontal ground. The charg-
ing station must not be tilted or bent.
Stuck in charging sta-
tion
There is an object in the way of the robotic
lawnmower preventing it from leaving the
charging station.
Remove the object.
Upside down
The robotic lawnmower is leaning too much
or has turned over.
Place the robotic lawnmower on a flat, level
surface, and start the robotic lawnmower
again.
Needs manual charg-
ing
The robotic lawnmower is set to the
Secon-
dary area
operating mode.
Place the robotic lawnmower in the charging
station. This behaviour is normal and no ac-
tion is required.
Next start hh:mm
The timer setting prevents the robotic lawn-
mower from operating.
Change the timer settings. See
Edit timer set-
tings on page 26
.
The clock on the robotic lawnmower is not
correct.
Set the time. See
Timer on page 24
.
Lifted
The lift sensor has been activated as the ro-
botic lawnmower has become trapped.
Free the robotic lawnmower.
Collision sensor prob-
lem, front/rear
The body of the robotic lawnmower can not
move freely around its chassis.
Check that the body of the robotic lawnmower
can move freely around its chassis.
If the problem remains, the message requires
action by an authorized service technician.
Wheel drive problem,
right/left
Grass or other object is wrapped around the
drive wheel.
Clean the wheels and around the wheels.
Alarm! Mower stop-
ped
The alarm was activated because the mower
was stopped.
Adjust the mower security settings in the
Se-
curity
menu, see
Security on page 30
.
Alarm! Mower lifted
The alarm was activated because the mower
was lifted.
Alarm! Mower tilted
The alarm was activated because the mower
was tilted.
Electronic problem
Temporary electronic or software related is-
sue in the mower.
Restart the mower.
If the problem remains, the message requires
action by an authorized service technician.
Loop sensor problem,
front/rear
Charging system
problem
Tilt sensor problem
Temporary problem
Temporary battery
problem
Temporary battery or software related issue
in the mower.
Restart the mower.
Disconnect and reconnect the battery.
If the problem remains, the message requires
action by an authorized service technician.
Battery problem
362 - 002 - 06.02.2018
Troubleshooting -
47