IBM 419452u Installation Guide - Page 30
Installing, simple-swap, Serial, drive
UPC - 883436026604
View all IBM 419452u manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Table 2. Locations of hard disk drive IDs 3.5-inch drive model servers 3.5-inch hard disk drive IDs 2.5-inch drive model servers 2.5-inch hard disk drive IDs Attention: To avoid damage to the hard disk drive connectors, make sure that the cover is in place and fully closed whenever you install or remove a hard disk drive. Installing a simple-swap Serial ATA hard disk drive Attention: Simple-swap hard disk drives are not hot-swappable. Disconnect all power from the server before you remove or install a simple-swap hard disk drive. To install a simple-swap Serial ATA hard disk drive, complete the following steps. Note: If you have only one hard disk drive, install it in the left drive bay. SATA hard disk drive back plate Hard disk drive assembly Filler panel Attention: To avoid damage to the hard disk drive connectors, make sure that the cover is in place and fully closed whenever you install or remove a hard disk drive. 1. Read the safety information that begins on page v and "Installation guidelines" on page 11. 2. Make sure that the server cover is in place and fully closed. 3. Turn off the server and peripheral devices, and disconnect the power cord and all external cables. 4. Remove the filler panel from the bay. 16 IBM System x3250 M2 Types 4190 and 4194: Installation Guide