Icom ID-52A About The Dv Gateway Function - Page 14

3 Terminal mode operation ■■Operating in the Terminal mode You can operate the transceiver as described below in the Terminal mode. What you can do while in the Terminal mode Display the TO SELECT screen. Switch transmit or receive. Display the RX HISTORY screen. Open the MENU screen. Turn the Key Lock function ON or OFF. Open the Quick Menu* window. Audibly announce the displayed Call Sign. Enter the Operating Call Sign Select mode. Display the RX History list. Adjust the audio volume level. Set "TO" (Destination). Turn the transceiver ON or OFF. Push [ENT]. Hold down [PTT] or release it to transmit or receive. LLWhile transmitting, the TX/RX indicator lights orange. LLWhile receiving, the TX/RX indicator lights green. LLWhile receiving a signal through the Internet, you cannot transmit. Hold down [CD] for 1 second. Push [MENU]. Hold down [LOCK] for 1 second. Push [QUICK]. Hold down [SPCH] for 1 second. LLHold down [QUICK] for 1 second when using the ID-31A PLUS/ID-31E PLUS. Hold down [CS] for 1 second. LLWhen using the ID-52A/ID-52E, you can check in the "Call Sign" setting. ([MENU] > SET > Call Sign) Hold down [RS→CS] for 1 second. Rotate [VOL]. Rotate [DIAL]. Hold down [ ] for 1 second. LLThe Terminal mode is not automatically canceled even if you turn OFF the transceiver, then ON it again. * You can select the following items (Quick Menu window) in the Terminal mode. Group Select Repeater Detail DTMF TX Voice TX GPS Information GPS Position Display Type DSQL ("D.SQL" for the ID-52A/ID-52E) Voltage TIP: See the transceiver's manual about each key operation. ID-31A PLUS/ID-31E PLUS Basic manual Section 2, 3, 11 Advanced manual Section 4, 11 ID-51A (PLUS2)/ID-51E (PLUS2) Basic manual Section 2, 4, 6 Advanced manual Section 8, 9, 16 ID-52A/ID-52E Basic manual Section 2, 3, D-STAR OPERATION Advanced manual Section 5, 12 14