Icom ID-52A About The Dv Gateway Function - Page 8

1 Preparation ■■Setting up a network DDWhen connecting your device to the Internet using a router The following are required to use the DV Gateway function. •• An Internet connection with an IPv4 Global IP address •• A static* local IP address set to your Windows or Android device •• Port forwarding of port 40000 Needs a Global IP address. * A static IP address to the Windows or Android device is recommended. Forward port number 40000. Internet Needs a Global IP address. Forward port number 40000. 1. A Global IP address A static or dynamic IPv4 Global IP address assigned to the router is needed. LLYour router may not have a Global IP address, depending on your Internet service provider. Ask your Internet service provider about the Global IP address setting. 2. Setting a static local IP address to your device When using a router, you need to set a static local IP address to the Windows or Android device. LLUsable IP addresses differ, depending on your router. Ask the router's manufacturer for details. LLDo not set the same IP address to two or more devices that are connected to the same router. LLAsk your Windows or Android device's manufacturer about the setting details. 3. Port forwarding When using a router, enable communication with the Internet, as described below. zz Forward the port number 40000 that is used in the RS-MS3W or RS-MS3A. zz "UDP" should be used as the port protocol. zz Set a static local IP address in Procedure 2 (2. Setting a static local IP address to your device) as a destination port. LLAsk the router's manufacturer about how to forward the port. LLOnly one Windows or Android device connected to the router can use the DV Gateway function at the same time. LLDepending on the router settings, you must configure the IP filter settings. Check the router's manual on how to configure the settings. → When using a Windows device, go to "Setting up the RS-MS3W." (p. 11) → When using an Android device, go to "Setting up the RS-MS3A." (p. 12) 8