Icom ID-52A About The Dv Gateway Function - Page 24
When not using the DR function, Enter the VFO mode., Set the operating frequency.
View all Icom ID-52A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
4 Access Point mode operation ■■Making a Gateway call through the Access point transceiver DDWhen not using the DR function In this document, the ID-51A (PLUS2)/ID-51E (PLUS2) is used as a Remote D-STAR transceiver as an example. 1. Enter the VFO mode. Push [V/MHz]. 2. Set the operating frequency. Rotate [DIAL] to set the frequency that is set to the Access Point transceiver. (Example: 430.850) 3. Set the Receive mode to "DV mode." Push [MODE] several times until "DV" is displayed. LLWhen the "GPS TX Mode" is set, "DV-G" or "DV-A" is displayed. 4. Set the duplex direction. 1. Push [QUICK]. 2. Select "DUP." 3. Select "DUP-." 24
4
Access Point mode operation
24
■
Making a Gateway call through the Access point transceiver
D
When not using the DR function
In this document, the ID-51A (PLUS2)/ID-51E (PLUS2) is
used as a Remote D-STAR transceiver as an example.
1. Enter the VFO mode.
Push [V/MHz].
2. Set the operating frequency.
Rotate [DIAL] to set the frequency that is set to the
Access Point transceiver. (Example: 430.850)
3. Set the Receive mode to “DV mode.”
Push [MODE] several times until “DV” is displayed.
L
When the “GPS TX Mode” is set, “DV-G” or “DV-A” is
displayed.
4. Set the duplex direction.
1. Push [QUICK].
2. Select “DUP.”
3. Select “DUP–.”