Intel E6320 Specification Update - Page 27
Performance Monitoring Event FP_MMX_TRANS_TO_MMX May
UPC - 735858192576
View all Intel E6320 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
BJ22. MOV To/From Debug Registers Causes Debug Exception Problem: When in V86 mode, if a MOV instruction is executed to/from a debug registers, a general-protection exception (#GP) should be generated. However, in the case when the general detect enable flag (GD) bit is set, the observed behavior is that a debug exception (#DB) is generated instead. Implication: With debug-register protection enabled (i.e., the GD bit set), when attempting to execute a MOV on debug registers in V86 mode, a debug exception will be generated instead of the expected general-protection fault. Workaround: In general, operating systems do not set the GD bit when they are in V86 mode. The GD bit is generally set and used by debuggers. The debug exception handler should check that the exception did not occur in V86 mode before continuing. If the exception did occur in V86 mode, the exception may be directed to the general-protection exception handler. Status: For the steppings affected, see the Summary Tables of Changes. BJ23. PEBS Record not Updated when in Probe Mode Problem: When a performance monitoring counter is configured for PEBS (Precise Event Based Sampling), overflows of the counter can result in storage of a PEBS record in the PEBS buffer. Due to this erratum, if the overflow occurs during probe mode, it may be ignored and a new PEBS record may not be added to the PEBS buffer. Implication: Due to this erratum, the PEBS buffer may not be updated by overflows that occur during probe mode. Workaround: None identified. Status: For the steppings affected, see the Summary Tables of Changes. BJ24. Performance Monitoring Event FP_MMX_TRANS_TO_MMX May Not Count Some Transitions Problem: Performance Monitor Event FP_MMX_TRANS_TO_MMX (Event CCH, Umask 01H) counts transitions from x87 Floating Point (FP) to MMX™ instructions. Due to this erratum, if only a small number of MMX instructions (including EMMS) are executed immediately after the last FP instruction, a FP to MMX transition may not be counted. Implication: The count value for Performance Monitoring Event FP_MMX_TRANS_TO_MMX may be lower than expected. The degree of undercounting is dependent on the occurrences of the erratum condition while the counter is active. Intel has not observed this erratum with any commercially available software. Workaround: None identified. Status: For the steppings affected, see the Summary Tables of Changes. Specification Update 27