Intel H2000WP Technical Product Specification - Page 41

Intel® Server Chassis H2000 Family TPS Hard Disk Drive Support  H2312xxJR/KR: 12x SAS/SATA 3.5" HDDs at 6Gb/s SAS/SATA or slower speeds, divided into 4 groups of three hot swap hard drives. Each HDD group is associated with one of the four compute nodes respectively in the 2U chassis.  H2216xx/JR/KR: 16x SAS/SATA 2.5" HDDs at 6Gb/s SAS/SATA or slower speeds, divided into 4 groups of four hot swap hard drives. Each HDD group is associated with one of the four compute nodes respectively in the 2U chassis.  One SGPIO SFF-8485 interface per compute node, total of four SGPIO on the backplane.  Three SMB interfaces supported on the HSBP: o SMBUS R1 - For chassis temp sensor and chassis FRU EEPROM device. o SMBUS R5 - Connectivity to up to two HSBP controllers and one shared 12V current monitoring device. o SMBUS R7 - Connectivity to up to two common redundant power supply (CRPS) module PMBus.  Integrated front panel control connectors  Status LED and Activity LED for each hard disk drive.  5V_AUX switcher regulator (from 12V and 12VSB) for HDD power and for compute nodes.  Each grouping of HDD slots has switches for 5V and 12V power, only when corresponding compute node is plugged in and operating will power be provided to the HDDs.  3.3V switcher regulator (from 12V) to power microcontroller, SAS/SATA re-drivers on the bridge board and various other components.  3.3V_AUX linear regulator (from 5V_AUX) for temp sensor, and chassis FRU EEPROM located on the HSBP.  Four 80-pin bridge board connectors, one per compute node.  Four compute node main power connectors, one per compute node.  Four 2x9pin power cable connections and one 2x9pin power control cable connections. These cables are routing to two power distribution boards (PDB).  Shared speaker for all compute nodes. Revision 1.0 31 Intel order number: G59059-001