Invacare XLT Owners Manual - Page 36
Adjusting Seat Fore/Aft - All Models Except XLT Gold, and Top End Force
View all Invacare XLT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
SECTION 6-RIDING POSITION Adjusting Seat Fore/Aft - All Models Except XLT Gold and Top End Force NOTE: For this procedure, refer to FIGURE 6.6. NOTE: Seat should be adjusted so that when seated with feet in the footrests, there is a slight bend at the knee and a slight bend at the elbow when the hand crank is furthest away. 1. If installed, activate parking brake. 2. Loosen, but DO NOT remove the four rear socket screws that secure the rear seat frame to the handcycle frame. 3. Loosen, but DO NOT remove the two front socket screws that secure the front of the seat frame to the handcycle frame. NOTE: There are socket screws on the right and left side of the handcycle. 4. Loosen, but DO NOT remove the hex bolts and locknuts that secure the two seat angle adjustment clamps to the rear seat supports. NOTE: There is one clamp on the right and left side of the handcycle. 5. Perform one of the following: • Moving the Seat Rearward ‐ While lifting up on the back support tubes, push the seat rearward to the desired position. • Moving the Seat Forward ‐ While pushing down on the back support tubes, pull the seat forward to the desired position. 6. Tighten the six socket screws that secure the seat frame to the handcycle frame securely. 7. Tighten the hex bolts and locknuts that secure the two seat angle adjustment clamps to the rear seat supports securely. Back Support Tube Seat Angle Adjustment Clamps Height Adjustment Clamp Front Socket Screw Rear Socket Screws Handcycle Frame Height Adjustment Bracket Seat Frame FIGURE 6.6 Adjusting Seat Fore/Aft - All Models Except XLT Gold and Top End Force Recumbent Handcycle Series 36 Part No 1114850