JVC KD-ADV38 Instructions - Page 380
Removing the unit, Connecting the reverse gear signal lead for rear view camera REVERSE GEAR SIGNAL
UPC - 046838030499
View all JVC KD-ADV38 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 380 highlights
When using the optional stay Fire wall Dashboard Stay (option) Screw (option) 30˚ Removing the unit Before removing the unit, release the rear section. Install the unit at an angle of less than 30˚. When installing the unit without using the sleeve In a car having the "Required space for installation" (see page 1), first remove the car radio and install the unit in its place. Flat type screws-M5 x 8 mm*2 *2 Not included for this unit. Bracket *2 Bracket *2 Flat type screws-M5 x 8 mm*2 Note: When installing the unit on the mounting bracket, make sure to use the 8 mm-long screws. If longer screws are used, they could damage the unit. Insert the two handles, then pull them as illustrated so that the unit can be removed. A Connecting the parking brake lead Connect the parking brake lead to the parking brake system built in the car. Parking brake Parking brake switch (inside the car) B Connecting the reverse gear signal lead (for rear view camera) (REVERSE GEAR SIGNAL) Locate the reverse lamp lead in the trunk. Parking brake lead (light green) To metallic body or chassis of the car Reverse lamp lead C Connecting the Mic unit 1 Microphone Microphone clip Reverse lamps 2 To reverse lamp Reverse lamp lead To car battery Purple with white stripe J Double-sided adhesive tape or Adjust the microphone angle Secure the microphone cord using cord cramps (not supplied) if necessary. 2