JVC KY-F1030U KY-F1030U digital camera 52 page instruction manual (550KB, PDF) - Page 16
Pin configurations of connectors
View all JVC KY-F1030U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
1. Introduction (continued) Pin configurations of connectors DC IN terminal (Mini DIN 8-pin, female) REMOTE terminal (Metal 10-pin, female) 7 8 1 8 6 7 2 Pin no. 1 2 3 4 5 6 7 8 5 3 2 4 1 NC GND NC NC GND 12V NC 12V Signal name LENS terminal (Metal 12-pin, female) 10 9 1 8 2 7 3 Pin no. 6 4 12 5 11 Signal name 1 NC 2 NC 3 GND 4 NC 5 6 7 8 9 to 12 IRIS CONTROL 12V DC 400mA max. IRIS POSITION IRIS AUTO /MANU NC CAUTION Use device whose current consumption is max. 400 mA or less. E12 10 9 Pin no. 1 2 3 4 5 6 7 8 9 10 6 5 3 4 Signal name A. WHITE L active TRG IN L active WEN L active 3.3V(p-p) FLASH NC RS-SDI RS-SDO GND 12V OPERATION CAUTION • Consult your JVC dealer concerning the remote terminal connection. • Remote cable must use shielded cable. Outer shield of remote cable must to connect 10-pin connector outer metal shell. • Do not input the external trigger during the first 5 seconds after the power is turned ON. Terminal name 2 TRG IN 3 WEN 4 FLASH I/O IN • 3.3V CMOS • Schmidt Trigger • Pull-up to 3.3V at 4.7k Ω OUT • 3.3V (p-p) negative polarity OUT • Open collector Conditions • Contact point recommended • Maximum rated voltage: 5.3V • H level: 2.4 ~ 5.0V • L level: 0 ~ 0.5V • Pulse width: 130 µs or higher • Maximum rated current: 150mA • Maximum rated voltage: 12V