JVC KY-F1030U KY-F1030U digital camera 52 page instruction manual (550KB, PDF) - Page 22
Connecting power, Connecting the IEEE1394 Cable
View all JVC KY-F1030U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
2. Before shooting (continued) Connecting power Between the 8 pin DC IN terminal on the rear of the main unit and the 8 pin TO CAMERA terminal of the AC adapter (AA-P700) connect the power cable (2m) which is provided. AC AA-P700 AC 100V AC adapter DC 12V=OUTPUT VIDEO OUTPUT S(Y/C) OUTPUT TO CAMERA EITHER OUTPUT MAX 1.25A SEE INSTRUCTION MANUAL ANALOG OUT LENS DC IN POWER IEEE1394 MD CONTROL REMOTE White marking Connect the end with the white marking to the AC adapter. [TO CAMERA] connector power cable (provided) SEE INSTRUCTION MANUAL [DC IN] connector DC IN POWER Plug Ring Ⅵ After inserting the plug completely, tighten the securing ring. Make sure white indication of power cable comes to AAP700 side. CAUTION • Be sure to use the AA-P700 power supply. Before connecting power cable, make sure that the power switch on the AA-P700 is set to OFF. Connecting with the power switch on may result in camera malfunction. • When connected through the digital output (Connecting through digital output connector (page E14)), power can be supplied from the PC but control of a motorized lens and analog output will not be possible. MEMO Wait at least 10 seconds before turning the power switch back on, when it has just been turned off. Turning the power switch on and off quickly may cause malfunctions, such as failure to boot, etc. Connecting the IEEE1394 Cable Ⅵ To reduce the emission of unwanted radio waves, make sure to attach the provided clamp filter as shown in the figure on the left. Ⅵ Attach the clamp filter as close to the KY-F1030 as possible as shown in the figure. To [IEEE1394] connector E18