JVC KY-F1030U KY-F1030U digital camera 52 page instruction manual (550KB, PDF) - Page 25
Settings and adjustments for shooting
View all JVC KY-F1030U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
3. Settings and adjustments for shooting Lens settings Set according to whether the used lens to be used is an auto-iris lens or a manual lens. Set the used Lens (Default setting: AUTO) Set the [IRIS MODE] on the [EXPOSURE] screen. (੬ page E33) AUTO : Setting when auto-iris lens is used in auto mode. MANUAL : Set when using a manual lens, using an auto-iris lens in MANUAL or no lens. * If the auto-iris lens cable is not connected to the [LENS] connector, the setting automatically becomes "MANUAL". Monitor adjustment The colour contrast and brightness are adjusted whilst, built-in test signals of the camera are being displayed on the PC monitor. [ANALOG OUT] [IEEE1394] ANALOG OUT IEEE1394 LENS DC IN POWER MD CONTROL REMOTE SEE INSTRUCTION MANUAL 1. Connect the [ANALOG OUT] connector or the [IEEE1394] connector to the PC. 2. Set the function setting switch NO.1 on the switch panel on the side of the KY-F1030 to "ON". ON OFF 1 23 4 3. Turn ON the KY-F1030, and then start the PC. * When connecting through the [IEEE1394] connector, power is supplied from the PC. Inside window UP/AW MENU SET DOWN 1 2 34 Default Setting Switch 4. Adjust the monitor. MEMO • For how to adjust, see the instructions for the employed monitor. • The peak level of the test signal is set to 0.7V from the fac- tory. To use 0.57V, change the setting by [TEST PATTERN] ➝ [LEVEL] on the [SYSTEM SETTING] screen. ੬ page E40 TEST PATTERN E21