JVC KY-F1030U KY-F1030U digital camera 52 page instruction manual (550KB, PDF) - Page 27
Settings and adjustments for shooting cont'd
View all JVC KY-F1030U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
3. Settings and adjustments for shooting (cont'd) Inside window UP/AW MENU SET DOWN 1 2 34 7. Press the [AW] (Auto White) button. ● When auto white is in operation, the auto-white operation area and [AUTO WHITE OPERATION] will be displayed on the monitor screen. ● When the white balance is successfully set, [AUTO WHITE OK] will appear for about 3 seconds on the screen and the unit will return to the normal screen. ʦ"8ʧ MEMO • When the shutter speed is set to a slow speed, it may take a while before the white balance operation is completed. • With the factory setting, it may take up to 13 seconds depending on the subject. (When setting the shutter speed to 1 s takes maximum of 1 minute 45 seconds.) Auto-white operation area ● Error display When the auto white balance cannot be set, one of the following error messages will appear and the unit will return to the normal screen. Auto white in operation NG: OBJECT (bad object) Displayed when the object consists of little whiteness or when the colour temperature is not correct. Change to a white object and redo the white balance. ERROR: LOW LIGHT (shortage of light) Displayed when the lighting is too dark. Brighten the lighting and redo the white balance. ERROR: OVER LIGHT (excessive light) • Displayed when the lighting is too bright. Close the lens iris or lower the brightness and redo the white balance. Auto white operation completed MEMO • When the colour temperature of the subject changes as the darkness increases, do not change the illumination. Instead, narrow the lens iris, and take the white balance again by pressing the [AW] (Auto White) button. • When a shutter speed exceeding 1 sec is used, it is not possible to launch the auto white balance function. Temporarily return the shutter setting to below 1 sec and launch the auto white balance function, or set the [WHITE BAL] item to "MANUAL" or "PRESET". • Pressing the [AW] button in the FREEZE condition, cancels the freeze. E23