Kenwood VRS-N8100 Instruction Manual - Page 32

Normal playback Input level adjustment (analog sources only) If the input level of an analog source signal is too high, the "CLIP" indicator will lights up to indicate the source signal. Adjust the input level. 1 Press the RCV Mode key on the remote control unit to set it to the receiver control mode. 2 Press the Sound key. 3 Use the MULTI CONTROL @ / # (or the Multi @ / # keys) to select "ANALOG INPUT LEVEL", and press the ENTER (or the Enter key). 4 Use the MULTI CONTROL % / fi (or the Multi % / fi keys) to adjust the input level. SOUND ANALOG INPUT LEVEL -3dB ÷ The adjustment mode is displayed for approximately 20 seconds. ÷ The input level may be adjusted to any one of three settings: 0dB, -3dB, and -6dB. (The initial setting is 0dB.) ÷ You can store a separate input level for each input selector. 5 Press the Sound key again to return to the input indication. ACTIVE EQ mode You can enjoy a more impressive sound effect when ACTIVE EQ is turned ON. Press the Active EQ key for the following selections: 1 "ACTIVE EQ MUSIC" : (The "ACTIVE EQ" indicator lights up) Effective when listening to music. 2 "ACTIVE EQ CINEMA" : (The "ACTIVE EQ" indicator lights up) Effective when watching a movie. 3 "ACTIVE EQ GAME" : (The "ACTIVE EQ" indicator lights up) Effective when playing a game. 4 "ACTIVE EQ OFF" : (The "ACTIVE EQ" indicator goes off) The ACTIVE EQ function is turned OFF. ÷ The ACTIVE EQ function is not available in when the REC MODE or virtual mode is ON. Muting the sound The Mute key lets you mute the sound of the speakers or headphones. Press the Mute key. To cancel Blinks Press the Mute key again so that the "MUTE" indicator goes off. ÷ MUTE ON can also be deactivated by turning the VOLUME CONTROL knob or pressing the VOL +/- keys. Receiver Operations 32 EN