Kenwood VRS-N8100 Instruction Manual - Page 78

In case of difficulty Resetting the Microcomputer The microcomputer may malfunction (unit cannot be operated, or shows an erroneous display) if the power cord is unplugged while the power is ON, or due to some other external factor. If this happens, please try either procedure below. Soft reset: This reset procedure allows the setups made by the user to be held without being reset. (For U.S.A and Canada) Press POWER ON/STANDBY key to turn this unit OFF (STANDBY), and then press POWER ON/STANDBY key again to turn it ON. ÷ If a memory card is inserted, remove the memory card after pressing POWER ON/STANDBY key to turn this unit OFF (STANDBY). After removal, press POWER ON/STANDBY key again to turn it on. Reset to the factory default setups: Unplug the power cord from the wall outlet, then plug it back in while holding down the POWER ON/STANDBY (For U.S.A and Canada) or ON/STANDBY key (For Europe and Australia). ÷ Please note that resetting the microcomputer will clear the contents of the memory and returns the unit to the state it was in when it left the factory. (For Europe and Australia) Press ON/STANDBY key to turn this unit OFF (STANDBY), and then press ON/STANDBY key again to turn it ON. ÷ If a memory card is inserted, remove the memory card after pressing ON/STANDBY key to turn this unit OFF (STANDBY). After removal, press ON/STANDBY key again to turn it on. Network Symptom The KENWOOD PC SERVER application cannot be installed in the PC or the installed application will not run. ÷ Check if the OS is supported. Remedy y The VRS-N8100 is not found in [My ÷ The PC server does not recognize the VRS-N8100. Computer] of the PC server. This unit cannot be used inside a firewall. ÷ Set the firewall to OFF. Playback interrupted or stopped while there is no problem in the network connection. ÷ The network may be congested. Stop other devices connected to the same network and retry. ÷ If wireless connection is in use, the transfer rate may be dropped due to interference from other devices. Stop equipment that generates radio waves such as a microwave oven and retry. The MOVIE, MUSIC or PHOTO files are ÷ Check the setup of the KENWOOD PC SERVER application. not displayed. ÷ Press "SAVE" of the KENWOOD PC SERVER and reload it. i i Audio is not output when a video data ÷ The audio format used by the file may be incompatible with this unit. Try a video data (movie file) (movie file) is played back. recorded using an audio format that is compatible with this unit. 4 The TV image is displayed in black and ÷ The video format of the video output from this unit does not match that of the TV. Check the white. "Video Out" setting. ¶ The image of a JPEG file cannot be ÷ The resolution of the image is higher than the maximum resolution of this unit or the file size is displayed. larger than the maximum file size. 4 The JPEG files in a memory card are not ÷ Check that the file has an extension of ".JPG" or ".JPEG". displayed. ÷ Check that the filename is composed only of alphanumeric characters (A to Z, 0 to 9, _). Some buttons are not displayed by the ÷ Ths display resolution setting is low. Increase the display resolution. KENWOOD PC SERVER application. Additional Information 78 EN