Konica Minolta Kodak i620 User Guide - Page 28

Ultrasonics calibration, Type: UDDS

Get Konica Minolta Kodak i620 PDF manuals and user guides View all Konica Minolta Kodak i620 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 28 highlights

Ultrasonics calibration NOTE: If calibration fails, check the Operator Log for details. See Chapter 6, "Accessing the Operator Log" for more information. You must wait at least 90 seconds before calibrating again. Use only an A4 size / 75-80 g/m2 or lettersize / 20 lb. bond paper to perform an Ultrasonics calibration. NOTE: The screens shown in this section are for the TWAIN Datasource. The screens displayed on your system may be different. 1. Center the side guides in the elevator tray and output tray. 2. Place the paper in the elevator tray in portrait orientation. 3. Follow Steps 5 - 12 above to access the Calibration dialog box. 4. Select Type: UDDS. Calibration begins. A confirmation box is displayed when calibration is complete 5. Click OK. NOTE: If calibration fails, check the Operator Log for details. See Chapter 6, "Accessing the Operator Log" for more information. 3-14 A-61500 April 2007

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
3-14
A-61500
April 2007
NOTE:
If calibration fails, check the Operator Log for details. See
Chapter 6, “Accessing the Operator Log” for more
information. You must wait at least 90 seconds before
calibrating again.
Ultrasonics calibration
Use only an A4 size / 75-80 g/m
2
or lettersize / 20 lb. bond paper to
perform an Ultrasonics calibration.
NOTE: The screens shown in this section are for the TWAIN
Datasource. The screens displayed on your system may be
different.
1.
Center the side guides in the elevator tray and output tray.
2.
Place the paper in the elevator tray in portrait orientation.
3.
Follow Steps 5 - 12 above to access the Calibration dialog box.
4. Select
Type: UDDS
. Calibration begins. A confirmation box is
displayed when calibration is complete
5. Click
OK
.
NOTE:
If calibration fails, check the Operator Log for details. See
Chapter 6, “Accessing the Operator Log” for more
information.