Konica Minolta Kodak i620 User Guide - Page 60

Operator Log Message Image buffer exceeded threshold Image outside document area Image size exceeds available memory Jam in transport Lamps not ready for calibration Lamps not ready for scanning Lamps ready for calibration Lamps ready for scanning Lamps timed out Lower imaging guide dirty or document in transport ID# 1, 48 286 301 30 Description/Action The feeder has stopped and the transport is still running because the scanner's internal image buffer is almost full. Processing will resume after the host computer has successfully retrieved enough images to allow the scanner to continue. • Be sure your host computer meets the recommended specifications to avoid this condition. Based on relative cropping parameters, the image to be generated from this document would be outside the document area. • Make sure the relative cropping offset, width and length are correct and that the correct document is being scanned. There is not enough room to store this image in the buffer using the current settings. • Lower the resolution setting before scanning the next batch of documents. • Select a different compression value. A document is lodged in the transport. • Remove the documents that have been scanned from the exit tray. • Open the pod. • Remove any jammed documents from inside the transport. • Close the pod. NOTE: The following procedure is a general guideline. Your procedure may be different depending on how your application is set up. • Verify the last document that was scanned correctly. • Place any documents that were not scanned at the top of the batch. • Place the documents in the elevator tray and begin scanning. One or more documents that passed through the transport were not scanned. • Refeed all documents for which images were not obtained. 110 Calibration was attempted before the lamps were warmed up. • Wait until the lamps have completely warmed (90 seconds) and try the calibration again. 252 Scanning was attempted before the lamps were warmed up. • Try to scan again. 278 Informational message. The lamps are warmed and the scanner is ready for calibration. 280 Informational message. The lamps are warmed and scanning can be started. 355 • Informational message. The lamps were turned off due to inactivity. 294, 694, The lower (rear) imaging guide is dirty or there may be a small 1094 piece of paper in the imaging guide area. • Follow the cleaning procedures in Chapter 5, Maintenance to clean the imaging guides. A-61500 April 2007 6-7