Konica Minolta Kodak i620 User Guide - Page 62

Operator Log Message Print head not installed Printer bitmap font in use Printer count exceeded maximum set value Refeed document set Scanner failed to enable Scanner failed initialization Scanner has lost synchronization Scanner interface cable reset Scanner paused for rotation or host processing Transport timeout Ultrasonics calibration failed ID# Description/Action 282 An attempt was made to use the Document Printer without a print head installed. • Be sure the cable is properly connected to the ink cartridge carrier and the ink cartridge is installed in the print head assembly. See Chapter 4, The Document Printer for more information. NOTE:The ink cartridge must be installed before turning on the scanner. 132 Informational message. At the time of this message, a bitmap printer font file was found on the Flash disk and is being used in lieu of the static font information built in the scanner software. 258 The printer count is larger than the maximum configured value. • Reconfigure the scanner to allow a larger value for the printer count. Refeed the document set. Documents passed through the transport but no images were created. • Refeed these documents and verify that the images have been captured. 52, 137, Documents passed through the transport but no images were 153, 537, created. 553, 937, • Refeed these documents and verify that the images have been 953 captured. 5 • The previous error condition has not been corrected. For example, there could be a document jam that has not been completely cleared. • Incomplete or conflicting image processing parameters. For example, selecting Error Diffusion for binarization and Noise Filter together. • See other log entries for the actual condition. 6 This error could occur during scanner power-up. • Power-down the scanner, then power down the PC. Wait a few seconds and then power the PC back up, then power up the scanner. • If the problem persists, call Service. 131, 531, An internal scanner sync condition has occurred. 931 • Clear the documents and power cycle the scanner. Rerun the job. • If the problem persists, call Service. 319 The scanner interface cable has reset. Some device on the FireWire bus was unplugged/plugged in. • Check that all FireWire connectors are securely fastened. 63 Informational message. Scanner paused. • Slow host PC may not be able to keep up with the scanner. • Auto rotation may be causing the scanner to slow down. 336 Informational message. The transport was turned off due to inactivity. 333 The Ultrasonics calibration failed. • Power up the scanner and try to calibrate again. Be sure you are using the correct ultrasonics calibration target. See Chapter 3, "Calibrating the scanner". A-61500 April 2007 6-9