Konica Minolta bizhub 283 bizhub 423/363/283/223 Network Scan/Fax/Network Fax - Page 195

9.2 One-Touch/User Box Registration 9 Item [No.] [Name] [Fax Number] [Line Settings] [Index] [Icon] [Overseas TX] [ECM OFF] [V.34 OFF] [Check Dest. & Send] [Select Line] Description Press [No.], and then enter the registration number of the destination between 1 and 2000 (or between 1 and 1000 if no Hard Disk is installed). Press [OK] without entering any number to register the smallest number available. Use the touch panel to enter the name to be registered in the address book using up to 24 characters. Enter the fax number for the destination using the keypad up to 38 digits. • When the PBX connection is enabled and a call is made from the internal line to the outside line, press [Pause] after the outside line number such as "0" so that dialing is made more surely. [P] is displayed on the screen. • When the PBX connection is enabled, [Outside] is displayed on the screen. When you select it, an [E-] is displayed. • If [Confirm Address (Register)] is ON, a screen for entering the fax number again appears after you press [OK]. Enter the fax number and then press [OK]. d Reference For details on the Confirm Address function, refer to page 10-22. Configure the line that is used to send faxes. The transmission rate is set to a lower level when having a poor communication. Error Correction Mode (ECM) is cancelled to shorten the transmission time. ECM is an error correction mode defined by ITU-T (International Telecommunication Union - Telecommunication Standardization Sector). Fax machines equipped with the ECM feature communicate with each other, confirming that the data sent is free of errors. V34 is a communication mode used for super G3 fax communication. When the remote machine or this machine is connected to a telephone line via PBX, however, you may not establish a communication in the super G3 mode depending on telephone line conditions. In this case, it is recommended that you turn V34 off to send data. After sending has been completed, this machine automatically returns to the V34 mode. The specified fax number is compared with the remote fax number (CSI) and data is sent only when those fax numbers match. If they do not match, the communication will fail; therefore preventing a sending error. • To check the destination and send, the fax number of this machine must be registered with the recipient's fax machine. If two fax expansion kits are installed, you can select [Line 1] or [Line 2] to send a fax. Specify the line used for sending faxes. Select the index. For a frequently used destination, specify the index characters and select [Favorites] at the same time. This allows you to find it more easily. Select an icon. • The selected icon is used for the image panel function that is available when the optional function code "CAA" is enabled. bizhub 423/363/283/223 9-10