Konica Minolta bizhub PRESS C71hc FD-9 Auto Scan Spectrophotometer User Guide - Page 14
Setting up FD-9, Necessary space
View all Konica Minolta bizhub PRESS C71hc manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Preparations ❙❙Setting up FD-9 The FD-9 should be set up on a flat, level surface with sufficient space for the color chart in front of and behind the FD-9. There should be enough space in front of the FD-9 for the color chart to be measured to be inserted into and ejected from the FD-9 without any obstacles, and enough space behind the FD-9 for the color chart to fully extend from the FD-9 without obstacles. (See below.) • If the FD-9 is set up on a rough surface or a surface which is not level, measurement accuracy may suffer. • Obstacles may cause the color chart to bend or be shifted to either side, resulting in damage to the color chart or misalignment during scanning. • After scanning, the scanned color chart will be ejected from the front of the FD-9. If the FD-9 is placed at the edge of a table, the ejected color chart might fall to the floor and be damaged. Necessary space 12