Konica Minolta bizhub PRESS C71hc FD-9 Auto Scan Spectrophotometer User Guide - Page 25

Taking measurements Measurements with the FD-9 are controlled from software, such as the included Measurement Utility Software FD-S2w. For details on taking measurements, please refer to the instruction manual for the software that you are using. ❙❙Feeding Test Charts into FD-9 • If the base mounting screws inside the cover are loose when measurements are taken, measurement accuracy may suffer. Be sure that the screws are firmly tightened. • If the test chart is curled or creased, it may result in a paper jam. Please measure only test charts without creases or excessive curl. Permissible curl amount: Feeding test charts manually • For information on feeding test charts when using the optional Auto Sheet Feeder FD-A09, please see below. 1 Place the end of the test chart on the Paper Guide, and slide the paper guides so that they are positioned touching the sides of the test chart as shown. 2 Slide the test chart gently between the guides and into the FD-9. When the test chart enters the FD-9 by a certain amount, it will be automatically pulled into the FD-9 for measurements. When the FD-9 starts pulling the test chart in, let go of the test chart. • Be sure to slide the test chart in straight. If the paper guide positions are too narrow or if the test chart goes in at an angle, the test chart may ride up onto the paper guides, which may cause measurement accuracy to suffer. Feeding test charts when using optional Auto Sheet Feeder FD-A09 1 When using the Auto Sheet Feeder, place the test charts in the supply tray and slide the paper guides so that they are positioned touching the sides of the test charts as shown. • The supply tray can hold up to 100 sheets of paper. Feeding of the test charts from the supply tray into the FD-9 is controlled by the software. For details, please refer to the software instruction manual. 23