Konica Minolta bizhub PRESS C71hc FD-9 Auto Scan Spectrophotometer User Guide - Page 23

repeatedly to set the desired value for the first number., to move to the next number.

Get Konica Minolta bizhub PRESS C71hc PDF manuals and user guides View all Konica Minolta bizhub PRESS C71hc manuals
Add to My Manuals
Save this manual to your list of manuals

Page 23 highlights

Connecting FD-9 to Computer 10 Press to select "Default gateway" and press highlighted. . The first number of the default gateway will be 11 Press or repeatedly to set the desired value for the first number. • Holding or pressed will cause the value to change continually. • Values between 0 and 255 can be set. If or is pressed again when the lowest or highest value has been reached, the number will change to the highest or lowest value. 12 Press to move to the next number. 13 Repeat steps 3 and 4 until all numbers have been set for the default gateway. 14 Press to select "SAVE DATA" and press . The message "Caution: It reboots after saving setting data" will be shown. 15 Press to save the settings and reboot the FD-9. Once these values have been set, connection to the FD-9 from within the same subnet can be performed by specifying the IP address during connection. 21

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
Connecting FD-9 to Computer
10
Press
to select “Default gateway” and press
. The first number of the default gateway will be
highlighted.
11
Press
or
repeatedly to set the desired value for the first number.
• Holding
or
pressed will cause the value to change continually.
•
Values between 0 and 255 can be set. If
or
is pressed again when the lowest or highest value has been reached, the number will change to the highest or
lowest value.
12
Press
to move to the next number.
13
Repeat steps 3 and 4 until all numbers have been set for the default
gateway.
14
Press
to select “SAVE DATA” and press
. The message
“Caution: It reboots after saving setting data” will be shown.
15
Press
to save the settings and reboot the FD-9.
Once these values have been set, connection to the FD-9 from within the same subnet can
be performed by specifying the IP address during connection.
21