Konica Minolta bizhub PRO 1100 bizhub PRO 1100 Daily Maintenance Guide - Page 65
When entry processing is completed
View all Konica Minolta bizhub PRO 1100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
15 Measure a misalignment between the marks of [1] to [4] printed on the [back] side of the output chart and the marks on the [front] side. [1] - The figure shows an example to measure [1]. The scale resolution is 0.5 mm. - In this figure, the black mark indicates the front side and the blue mark indicates the back side. - Measure a misalignment between printing positions in the horizontal direction (X axis) and vertical direction (Y axis). - The measurement value can be entered in units of up to 0.1 mm. - For example, as shown in the figure, if at point [1] is misaligned 2.0 mm in the plus side of the X direction and 1.5 mm in the minus side of the Y direction compared with the front side, press [2] - [0] - [+/-] in the X direction to enter "-2.0" as the adjustment value, and press [1] - [5] in the Y direction to enter "+1.5" as the adjustment value. Then, at point [1], the blue line on the back side will be moved 2.0 mm toward the minus side of the X direction and 1.5 mm toward the plus side of the Y direction. - Write down the measured values so that you do not forget them. 16 Press [X] or [Y] at each point, and enter the measured value using the keypad, [,], or [+] on the screen. - If the printing position is misaligned to the minus (-) side, enter a positive value (+). If the printing position is misaligned to the plus (+) side, enter a negative value (-). - To reset a value, press [Clear]. - To switch the positive sign (+) and negative sign (-), press [+/-]. 17 When entry processing is completed, press [Adjustment Start]. bizhub PRO 1100 back 2 2-39