Lenovo ThinkCentre A58e Hardware Maintenance Manual - Page 68

Miscellaneous error messages, The following table describes miscellaneous error messages.

Get Lenovo ThinkCentre A58e PDF manuals and user guides View all Lenovo ThinkCentre A58e manuals
Add to My Manuals
Save this manual to your list of manuals

Page 68 highlights

POST error message CMOS battery failed CMOS checksum error - defaults loaded CPU at nnnn Press Esc to skip memory test HARD DISK INSTALL FAILURE Keyboard error or no keyboard present Memory test: Memory test fail Press TAB to show POST screen Error: Non-System disk or disk error Replace and press any key when ready Description/Action The CMOS battery is no longer functional. Replace the battery. Checksum of CMOS is incorrect. The computer loads the default configuration settings. This error might indicate that CMOS has become corrupt due to a weak CMOS battery. nnnn is the running speed of the microprocessor. Pressing Esc skips the full memory test. Cannot find or initialize the hard disk drive controller or the drive. Make sure the hard disk drive is correctly installed. If no hard disk drives are installed, make sure the hard disk drive selection in setup is set to NONE. Cannot initialize the keyboard. Make sure the keyboard is correctly connected to the computer and that no keys are held pressed during POST. To purposely configure the computer without a keyboard, set the error halt condition in Setup to HALT ON ALL, BUT KEYBOARD. The BIOS then ignores the missing keyboard during POST. This message displays during a full memory test, counting down the memory areas being tested. If POST detects an error during memory testing, additional information appears. This information gives specifics about the type and location of the memory error. Pressing the TAB key permits the user to toggle between the default POST display screen and a custom POST display screen. The BIOS was unable to find a suitable boot device. Make sure the boot drive is correctly connected to the computer. Make sure you have bootable media. Miscellaneous error messages The following table describes miscellaneous error messages. Message/Symptom Changing display colors Computer will not power-off. See "Power problems" on page 33. FRU/Action Display/Monitor 1. Power switch 2. System board 3. Riser card, if installed 62 Hardware Maintenance Manual

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
POST error message
Description/Action
CMOS battery failed
The CMOS battery is no longer functional.
Replace the battery.
CMOS checksum error - defaults loaded
Checksum of CMOS is incorrect.
The computer loads the default configuration settings.
This error might indicate that CMOS has become corrupt
due to a weak CMOS battery.
CPU at nnnn
nnnn is the running speed of the microprocessor.
Press Esc to skip memory test
Pressing Esc skips the full memory test.
HARD DISK INSTALL FAILURE
Cannot find or initialize the hard disk drive controller or
the drive.
Make sure the hard disk drive is correctly installed.
If no hard disk drives are installed, make sure the hard
disk drive selection in setup is set to NONE.
Keyboard error or no keyboard present
Cannot initialize the keyboard.
Make sure the keyboard is correctly connected to the
computer and that no keys are held pressed during POST.
To purposely configure the computer without a keyboard,
set the error halt condition in Setup to HALT ON ALL, BUT
KEYBOARD. The BIOS then ignores the missing keyboard
during POST.
Memory test:
This message displays during a full memory test, counting
down the memory areas being tested.
Memory test fail
If POST detects an error during memory testing, additional
information appears. This information gives specifics
about the type and location of the memory error.
Press TAB to show POST screen
Pressing the TAB key permits the user to toggle between
the default POST display screen and a custom POST
display screen.
Error: Non-System disk or disk error Replace and press
any key when ready
The BIOS was unable to find a suitable boot device.
Make sure the boot drive is correctly connected to the
computer.
Make sure you have bootable media.
Miscellaneous error messages
The following table describes miscellaneous error messages.
Message/Symptom
FRU/Action
Changing display colors
Display/Monitor
Computer will
not
power-off. See “Power problems” on
page 33.
1. Power switch
2. System board
3. Riser card, if installed
62
Hardware Maintenance Manual