Lexmark C524 Menus and Messages Guide - Page 36

Using printer menus Menu item USB Buffer Job Buffering Mac Binary PS ENA Address ENA Netmask ENA Gateway Purpose Values Configures the size of the USB input buffer. Note: Changing the USB Buffer menu item automatically resets the printer. Disabled *Auto 3K to maximum size allowed (1K increments) Temporarily stores jobs on the printer hard disk before printing. Note: Changing the Job Buffering menu item automatically resets the printer. *Off On Auto Configures the printer to process On Macintosh binary PostScript print jobs. Off *Auto Sets the USB port ENA Address. Sets the USB port ENA Netmask. Sets the USB port ENA Gateway. 4 field IP address Job buffering is disabled. Any jobs already buffered on the disk are printed before normal processing of incoming jobs resumes. Printer automatically calculates the USB Buffer size (recommended setting). The user specifies the USB Buffer size. The maximum size depends on the amount of memory in the printer, the size of the other link buffers, and whether Resource Save is set to On or Off. To maximize the range for the USB Buffer size, disable or reduce the size of the parallel, serial, and network buffers. Does not buffer print jobs to the hard disk. Buffers print jobs to the hard disk. Buffers print jobs only if the printer is busy processing data from another input port. Printer filters PostScript print jobs using standard protocol. Printer processes raw binary PostScript print jobs from computers using the Macintosh operating system. Note: This setting often causes Windows print jobs to fail. Printer processes print jobs from computers using either Windows or Macintosh operating systems. Shown only if an ENA is attached through the USB port. Parallel and Parallel Use these menu items to change printer settings affecting jobs sent to the printer through a parallel port (either Std Parallel or Parallel ). Menu item PCL SmartSwitch Purpose Values Configures the printer so it *On automatically switches to PCL emulation when a print job received through the parallel port requires it, regardless of the default printer language. Off Printer examines data on the parallel interface and selects PCL emulation if the data indicates that is the required printer language. Printer does not examine the incoming data. The printer uses PostScript emulation to process the job if PS SmartSwitch is On, or uses the default printer language specified in the Setup Menu if PS SmartSwitch is Off. Menu Groups 36