Lexmark C524 Menus and Messages Guide - Page 48

Understanding printer messages Message 39 Page is too complex to print 50 PPDS font error 51 Defective flash detected 52 Not enough free space in flash memory for resources 53 Unformatted flash detected 54 Serial option error 54 Network software error 54 Standard network software error 55 Unsupported option in slot 56 Parallel port disabled 56 Standard parallel port disabled 56 Serial port disabled Action • Press until Continue appears, and then press the message and continue printing. The job may not print correctly. • Cancel the current job. • Install additional printer memory. to clear • Press until Continue appears, and then press the message and continue printing. The job may not print correctly. • Cancel the current job. to clear Press until Continue appears, and then press message and continue printing. to clear the Install different flash memory before downloading any resources to flash. • Press until Continue appears, and then press the message and continue printing. to clear Downloaded fonts and macros not previously stored in flash memory are deleted. • Delete fonts, macros, and other data stored on the flash memory. • Install a larger capacity flash memory card. Press until Continue appears, and then press message and continue printing. to clear the Format the flash memory before storing any resources on it. If the error message remains, the flash memory may be defective and require replacing. • Make sure the serial link is set up correctly, and the appropriate cable is in use. • Make sure the serial interface parameters (protocol, baud, parity, and data bits) are set correctly on the printer and host computer. • Press until Continue appears, and then press to clear the message and continue printing. The job may not print correctly. • Turn the printer off and then on to reset the printer. • Press until Continue appears, and then press the message and continue printing. The job may not print correctly. • Program new firmware for the network interface. • Reset the printer. to clear 1 Turn the printer off. 2 Unplug the power cord from the wall outlet. 3 Remove the unsupported option. 4 Connect the power cord to a properly grounded outlet. 5 Turn the printer on. • Press until the message. Continue appears, and then press to clear The printer discards any data received through the parallel port. • Make sure the Parallel Buffer menu item is not set to Disabled. • Press until the message. Continue appears, and then press to clear The printer discards any data received through the serial port. • Make sure the Serial Buffer menu item is not set to Disabled. Understanding printer messages 48