Lexmark C950 Service Manual - Page 295

5058-030 Automatically Display Error Screens To change this setting: 1. From the Configuration Menu, navigate to Automatically Display Error Screens. 2. Touch or to change the setting. 3. Touch Submit to save the setting, or touch Back to return to the Configuration Menu without saving any changes. Black Only Mode Previous Next Go Back This mode enables a user to force the printer to always print color content in grayscale. Turning this setting On is equivalent to setting Print Mode to Black Only; the printer will ignore any PJL or datastream commands that attempt to change the Print Mode setting. If this setting is Off, then the printer will print color content as normal. To change this setting: 1. From the Configuration Menu, navigate to Black Only Mode. 2. Touch or to change the setting. 3. Touch Submit to save the setting, or touch Back to return to the Configuration Menu without saving any changes. Booklet Adjustments The Booklet Adjustment menu enables the user to correct any folding overlap or skew overlap errors that occur when the device performs folding or saddlestitch finishing on a job that uses a specific combination of media size and total number of sheets (example: a 2-sheet, Letter-sized job). Clear Custom Status Executing this operation erases any strings that have been defined by the user for the Default or Alternate custom messages. Color Trapping Color trapping is used to compensate for mechanical misregistration in the printer. When small black text or fine black lines are being rendered, the printer checks to see if they are being rendered on top of a colored background. Rather than remove the color from beneath the black content, the printer leaves the color around the edge of the text or line. In this way, the "hole" in the colored region is reduced in size which prevents the characteristic "white gap" that is caused by misregistration. The values 1 through 5 indicate the amount of color that will remain beneath the black content. The more inaccurate the registration setting, the higher this setting will need to be adjusted. To change this setting: 1. From the Configuration Menu, navigate to Color Trapping. 2. Touch or to change the value. 3. Touch Submit to save the setting, or touch Back to return to the Configuration Menu without saving any changes. Disk Encryption This setting controls whether the device encrypts the information that it writes to its hard disk (when installed). Diagnostic aids 3-7