Lexmark C950 Service Manual - Page 309

5058-030 FINISHER MOTOR TESTS To run these tests: 1. From the Diagnostics Menu, navigate to MOTOR TESTS. 2. Select FINISHER MOTOR TESTS. 3. Select the test from the following options: Available tests: • Buffer/transport motor • Entrance/paddle motor • Exit motor • Finisher diverter gate solenoid (upper bin) • Finisher diverter gate solenoid (stacker bin) • Sub paddle solenoid • Buffer diverter gate solenoid • Front tamper motor (forward) • Front tamper motor (rearward) • Rear tamper motor (forward) • Rear tamper motor (rearward) • Stapler carriage motor (forward) • Stapler carriage motor (rearward) • Media eject clutch • Media eject clamp motor (unclamp) • Media eject clamp motor (clamp) • Media eject motor (forward) • Media eject motor (reverse) • Stacker bin lift motor (up) • Stacker bin lift motor (down) • Punch carriage shift motor (forward) • Punch carriage shift motor (rearward) • Punch unit motor • Bridge unit motor • Decurler cam clutch • Booklet folding/exit motor (forward) • Booklet folding/exit motor (reverse) • Booklet knife solenoid • Booklet end guide motor (down) • Booklet stapler motor • Booklet bin motor • Booklet paddle motor • Booklet tamper front motor (reverse) • Booklet tamper front motor (forward) • Booklet tamper rear motor (forward) • Booklet tamper rear motor (reverse) • Booklet entrance motor • Booklet diverter gate solenoid (bin) • Booklet diverter gate solenoid (booklet) • Previous Next Go Back OUTPUT BIN TESTS Feed Tests (Output Bin) This test is used to verify that media from the device's default input source can be fed to a specific output bin. No information is printed on the feed test pages. To run the Feed Tests for the output bins: 1. From the Diagnostics Menu, navigate to OUTPUT BIN TESTS. 2. Touch Feed Tests. 3. Touch the output bin you want the paper to exit into. The standard bin as well as any output option bin installed on the printer is shown on the menu. • Standard Bin • Output Bin [1-3] 4. Touch either Single or Continuous. • Single-Feeds one sheet of media from the selected source. • Continuous-Media continues feeding from the selected source until Stop is pressed. Press Stop to return to the [Selected Output Bin]. Diagnostic aids 3-21