Lexmark Optra E Service Manual - Page 57

4026-0XX Wrinkled Paper/Envelope/Transparency FRU Action 1 Paper Check the paper supply for wrinkled or damaged paper, out of specification paper, envelopes or transparency material. Correct as necessary. 2 Paper Path Check the paper feed lift plate assembly, input sensor actuator, paper separators, paper feed rollers or anything in the paper path that might catch the paper or cause the paper to wrinkle. Paper Never Leaves The Tray or Fails To Reach The Input Sensor Note: Remove the Optional Second Paper Tray if installed before performing the following checks. FRU Action 1 Paper Check the paper supply for any paper, envelope, transparency, label, or index cards that may be causing a problem. 2 Paper Take- Be sure the paper take-up solenoid is picking. If Up Solenoid incorrect go to the "Paper Take-Up Solenoid Service Check" on page 2-32. 3 Paper Frame Check the paper feed frame assembly for proper Assembly operation. If incorrect go to the "Paper Feed Frame Assembly Service Check" on page 2-37. 4 D-Roll Check the D-Roll assembly for proper operation. Assembly If incorrect go to the "D-Roll Assembly Service Check" on page 2-16 5 Paper Lift Check the paper lift plate assembly for proper Plate Assem- operation. If incorrect, replace the paper lift plate bly assembly. 6 Print Media Check the print media selection lever on models Selection 06C and 06F for the correct setting. This is Lever determined by the media being used ( labels, card stock, paper, etc. ). (Models 06C and 06F) Diagnostic Information 2-35