Lexmark X925 User's Guide - Page 181

Understanding printer menus Menu item Alarms Alarm Control Cartridge Alarm Timeouts Standby Mode 1-240 Disabled Timeouts Sleep Mode Disabled 1-240 min Timeouts Screen Timeout 15-300 sec Timeouts Print Timeout Disabled 1-255 sec 181 Description Sets an alarm to sound when the printer requires operator intervention Available options for each alarm type are: Single Continuous Off Notes: • Single is the factory default setting. Single sounds three quick beeps. • Continuous repeats three beeps every 10 seconds. • Off means no alarm will sound. Specifies the number of minutes of inactivity before the system enters a lower power state Note: 15 minutes is the factory default setting. Sets the amount of time the printer waits, after a print job is finished, before it goes into a reduced power state Notes: • 5 minutes is the factory default setting. • Lower settings conserve more energy, but may require longer warm‑up times. • Select the lowest setting if the printer shares an electrical circuit with room lighting. • Select a high setting if the printer is in constant use. Under most circumstances, this keeps the printer ready to print with minimum warm‑up time. Sets the amount of time in seconds the printer waits before the printer displays Ready Note: 30 seconds is the factory default setting. Sets the amount of time in seconds the printer waits to receive an end‑of‑job message before canceling the remainder of the print job Notes: • 90 seconds is the factory default setting. • When the timer expires, any partially printed page still in the printer is printed, and then the printer checks to see if any new print jobs are waiting. • Print Timeout is available only when using PCL emulation. This setting has no effect on PostScript emulation print jobs.