Magnavox 50MV336X/F7 Owners Manual English - Page 35

Search for channels Be sure the RF cable is correctly connected to this Unit and you are registered with your Cable TV provider when you Install Cable channels. 1 Press Z and use J K to Select Setup then press OK. 2 Use H I J K to Select Search for channels, then press OK. 3 Use J K to Select Start, then press OK. Install channels You can search and store all channels. If you move the unit to a different area after the initial setting, it is recommended to perform Autoprogramming. 4 Use H I to Select Antenna or Cable, then press OK. 5 Press OK on Start. ● When the Scanning and Memorizing of Available Channels is Completed, the Lowest Memorized Channel will be Displayed. 6 Follow the On-screen Instructions to Complete the Installation. System searching. Please wait... Auto programming may take more than 20 minutes to complete. Digital channels found: 0 Analog channels found: 0 Total progress: 1 2 Stop 34 Channel settings 1 Press Z and use J K to Select Setup then press OK. 2 Use H I J K to Select Channel settings, then press OK. 3 Adjust the following items. Channel installation Child lock Change PIN Digital audio language Mono/Stereo Weak channel installation Installation mode Uninstall channels 35 .English Channel installation Be sure the RF cable is correctly connected to this Unit and you are registered with your Cable TV provider when you Install Cable channels. Weak channel installation This function lets you add the channels that were not added by the AutoProgram due to the reception conditions during the initial setup. It is available only when you select Antenna in Installation mode. 1 Use H I to Select Channel installation, then press OK. 2 Use H I to Select Weak channel installation, then press OK. 3 Use H I to Select Search, then press OK. ● The PIN code will be required if you have locked channels. 4 Use H I to Select a channel you want to memorize. 5 Use J K to Select Search, then press OK. 6 Display will be changed to Store from Search when the channel is found, then press OK. Note(s) ● In most cases, Digital channels are not broadcast on the RF channel on which they appear on your TV. To add Digital channels you need to know the RF channel on which the Digital channel is being broadcast. (e.g. If there is a Digital channel 9.1 which is being broadcast on RF channel 25, you need to enter 25 while performing a weak channel installation.) To find out the RF channel on which a particular Digital channel is being broadcast, please contact your local service provider. Installing Digital channels using Weak channel installation might not work for direct cable connections and if the Digital signal is too weak for the TV to process. Installation mode 1 Use H I to Select Channel installation, then press OK. 2 Use H I to Select Installation mode, then press OK. 3 Use H I to Select Antenna or Cable, then press OK. ● When Antenna is selected, the TV detects antenna signals. It searches for DTV and Analog TV channels available in your area. ● When Cable is selected, the TV detects signals supplied by cable. It searches for DTV, Analog TV and Cable channels available in your area. Uninstall channels The channels selected here can be skipped when selecting the channels using CH + / -. Those channels can still be selected with the NUMBER buttons. 1 Use H I to Select Channel installation, then press OK. 2 Use H I to Select Uninstall channels, then press OK. 3 Use H I to Select the channel you want to remove, then press OK. ● The removed channels are not displayed on the list of Favorite channels. ● To reactivate a removed channel, use H I then press OK. Continued on next page.