Marantz SR4600 SR4600 User Manual - Page 24

3. PREFERENCE 1. 4 3. 4. 2. 4. ND RECEIVER SR4600 DISP MULTI AUTO TUNED SLEEP AUTO SURR DIRECT ST V - OFF NIGHT PEAK ATT DISC 6.1 MT X 6.1 EQ ANALOG DIGITAL SURROUND DIGITAL LCR AAC PCM LFE SL S SR D EAKER NES SURROUND MODE PURE DIRECT SIMPLE SETUP AUTO HT-EQ MENU ENTER DISPLAY MEMORY CLEAR EXIT BAND T-MODE 3. 4. TV VOL. SLEEP MUTE MAIN VOL. OSD MENU 1. 4. ENTER SET UP/ T.TONE PURE DIRECT AUTO MENU OFF DTS 2. 4. 1. Select "3. PREFERENCE" in SETUP MENU with or cursor button. 2. Press the ENTER button. 3. Press or cursor button to select desired item. 4. Press or cursor button to set the mode. 5. When you select "TO MAIN MENU" by pressing the or button, you can return the SETUP MENU by pressing the ENTER button. Or press the or cursor button to select "EXIT" then press the ENTER button to exit the SETUP MENU. BASS MIX • The BASS MIX setting is only valid when "LARGE" is set for the front speakers and "YES" is set for the subwoofer at stereo playback . • When the "BOTH" is selected, the low frequency signal range of "LARGE" are produced simultaneously from those channels and the subwoofer channel. When actual low frequency sound volume is weak depending on room size, use this function to fill low frequency sound equally in the room. • When "MIX" is selected, subwoofer output is determined depending on the speaker sizes for each channels. If the front speaker size is set to "Large", subwoofer output is only the LFE signal contained in Dolby Digital or DTS processed signals. Note: • When Front speaker is set "SMALL", then BASS MIX is set "MIX". (The display appears "BASS MIX MMEENNUU SSTTRRUUCCTTUURREEooffPPRREEFFEERREENNCCEEsesteutpup 3.PREFERENCE STBY NOMAL ECONOMY STANDBY MODE: When this function is set to "ECONOMY", you can reduce the power consumption when the unit is in the standby mode. BASS BOTH The low frequency signal range of front L/R are outputted to a subwoofer simultaneously with the LFE signal. For L&R is "SMALL" : MIX The low frequency signal range of front L/R are outputted to a subwoofer simultaneously with the LFE signal. For L&R is "LARGE" : The low frequency signal range of front L/R are not output to subwoofer. *** This menu (BASS) will not be displayed, if SUBW is set "NONE". 7.1-V LAST>TV>DVD>...>V-OFF> TO MAIN MENU EXIT exit SETUP MENU 4. SURROUND This sub menu is to adjust channel levels for each surround setting groups. There are three surround setting groups shown below. Therefore if settings for a surround mode are changed, settings for all other surround modes in the same group are also changed. Surround setting group 1 : AUTO, DOLBY, DTS, EX/ES, VIRTUAL, STEREO 2 : Multi-ch stereo 3 : CS II 1. 3. 5. 4. 5. 2. 5. ND RECEIVER SR4600 DISP MULTI AUTO TUNED ST V - OFF NIGHT PEAK ATT ANALOG SURROUND SLEEP AUTO SURR DIRECT DISC 6.1 MTX 6.1 EQ DIGITAL DIGITAL LCR AAC PCM LFE SL S SR D EAKER NES SURROUND MODE PURE DIRECT SIMPLE SETUP AUTO HT-EQ MENU ENTER DISPLAY MEMORY CLEAR EXIT BAND T-MODE 4. 5. TV VOL. SLEEP MUTE MAIN VOL. OSD MENU 1. 3. 5. ENTER SET UP/ T.TONE PURE DIRECT AUTO MENU OFF DTS 2. 5. 1. Select "4. SURROUND" in SETUP MENU with or cursor button. 2. Press the ENTER button. 3. To select a desired item, press or cursor button. 4. Using the or cursor button to select the mode or adjust the volume level of each speaker. 5. When you select "TO MAIN MENU" by pressing the or button, you can return the SETUP MENU by pressing the ENTER button. Or press the or cursor button to select "EXIT" then press the ENTER button to exit the SETUP MENU. SR(SURR-MODE) : Select the desired surround mode with or cursor button. • If one of the following modes is selected, all other modes are also set to the same. AUTO, DOLBY, DTS, EX/ES, VIRTUAL, STEREO. HT-EQ : Select to active the HT-EQ with the or cursor buttons. The tonal balance of a film soundtrack will be excessively bright and harsh when played back over audio equipment in the home. This is because film soundtracks were designed to be played back in large movie theater environments. Activating the HT-EQ feature when watching a film made for movie theaters corrects this and restores the correct tonal balance. The HT-EQ feature is available except in the following modes. • 7.1 CH INPUT • PURE-DIRECT • When VIRTUAL is set for the surround mode LFE LEVEL : Select the output level of the LFE signal included in the Dolby Digital signal or the DTS signal. Select 0 dB, -10 dB or OFF with the or cursor buttons. When you select "TO MAIN MENU" by pressing the or button, you can return the SETUP MAIN MENU by pressing the ENTER button. MMEENNUU SSTRUCCTTUURREEooffSSUURRRROOUUNNDDsesteutpup 4.SURROUND SURROUND MODE HT-EQ LFE TO MAIN MENU EXIT exit SETUP MENU 21 ENGLISH