Marantz SR7002 User Manual - English - Page 10

ENGLISH OPERATION OF REMOTE CONTROLLER REMOTE CONTROL Operate the remote controller within a distance of approx. 5m from the infrared receptor window on the front of the unit. SR7002/8002 Approx. 5 m 60° INPUT AV SELECTOR SURROUND RECEIVER SR8001 STANDBY POWER ON/OFF PHONES DISP SLEEP MULTI AUTO AUTO SURR DTIRUENCETD ST DISCS6P.1KR A B MT XV6-.O1 FF PEAK NIGHT ATT DAINGAITLAOLG AAC PCM DSLUIGRIRTAOLUND C SL LFE R S SR ENTER DOWN VOLUME UP DIGITAL S-VIDEO AUX 1 INPUT VIDEO L AUDIO R CH CLEAR OK PREV 7 4 DISP 0 1 7.1CH TESTMENU 2 CH.SEL GUIDE 5 ATT 8 OSD 3 SURREXIT 6 SPK-AB 9 SLEEP MUTE TV TUNER DVD TAPE 1 AUX1 Learning LIGHT RemRoCte14C0o0ntroller CD AUX2 2 VCR CD-R MD AMP DSS MEMO OFF ONP/OOFWF ER SOURCE ON M D1 D2 D3 D4 D5 VOL Remote controller Caution: • Do not allow direct sunlight, an inverter fluorescent light or other strong source of light to shine onto the player's infrared receptor window. Otherwise, the operation of the remote controller may be disabled. • Bear in mind that operating the remote controller may cause other devices operated by infrared rays to be operated by mistake. • The remote controller cannot be operated if the space between the controller and the player's infrared receptor window is obstructed. • Do not place any objects on top of the remote controller. Doing so may cause one or more buttons to be held down which will cause the batteries to run down. LOADING BATTERIES Before using the remote controller for the first time, load the batteries in the remote controller. The batteries provided are used to verify the operations of the remote controller only. 1. Remove the back cover. 2. Insert the new batteries (AAA type) with correct ª and · polarity. 3. Close the battery cover until it clicks shut. 1. Remove the battery cover. 2. Insert the new batteries (AAA type) with correct ª and · polarity. 3. Close the battery cover until it clicks shut. CAUTIONS ON BATTERIES • Use "AAA" type batteries in this remote controller. • We recommend that you use alkali batteries. • The life of the batteries used with the remote controller is about 4 months with normal use. • If the remote controller does not operate from close to the unit, replace the batteries with new ones, even if less then a year has passed. • The included battery is only for verifying operation. Replace it with a new battery as soon as possible. • When inserting the batteries, be careful to do so in the proper direction, following the + and - marks in the remote controller's battery compartment. • To prevent damage or battery fluid leakage: - Do not use a new battery with an old one. - Do not use two different types of batteries. - Do not short-circuit, disassemble, heat or dispose of batteries in flames. • Remove the batteries when not planning to use the remote controller for a long period of time. • If the batteries should leak, carefully wipe off the fluid from the inside of the battery compartment, then insert new batteries. • When disposing of used batteries, please comply with governmental regulations or environmental public instruction's rules that apply in your country or area. BATTERY REPLACEMENT INTERVAL (RC8001SR) When the batteries wear out, a battery mark is displayed on the LCD. Although the remote control can still be used when the battery mark is displayed, the batteries should be replaced as soon as possible. The LCD eventually starts to flash when buttons are pressed, the remote control will be unable to transmit signals or learn codes. • This remote control uses non-volatile memory so that the learned codes and macro programs are retained even if the batteries are removed. • Reset the clock after replacing the batteries. 7