Marantz SR7002 User Manual - English - Page 51

ENGLISH ERROR MESSAGES Displayed Error MIC SET ERROR!! AUTO SETUP AUTO SETUP: START MAIN ROOM SURR BACK: 2CH MIC SET ERROR!! RETURN EXIT NOISE ERROR!! AUTO SETUP SPEAKERS CHECK: NOISE ERROR !! Cause • The microphone is not properly connected. How to Remedy • Connect the included microphone. • Check the microphone connection. • There is too much noise in the listening room to measure properly. • Volume from the speakers is low. • During measurement, turn off devices that make noise such as air conditioners. • Measure at a time when the surrounding area is quiet. RETURN EXIT ANALYZE ERROR!! AUTO SETUP SPEAKERS CHECK: ANALYZE ERROR !! RETURN NEXT EXIT * Under ANALYZE ERROR, select "NEXT" with the 3/4 cursor buttons and press the OK/ENTER button. A detail screen like the following appears on the display. SPEAKER CONFIG CHECK !! SPEAKER FRONT L : YES REV CENTER : NON FRONT R : YES REV SURR.R : NON ERR SURR.B R : YES ERR SURR.B L : YES ERR SURR.L : NON ERR SUB W : YES RETURN EXIT • The speakers required for suitable playback were not detected. • Speaker polarity is connected backwards. In the examples at left, the following trouble is detected. • The polarity of the left and right channels of the front speakers is backwards ([REV] appears on the display.) • The surround speaker is not connected ([NON] is displayed), but the surround back speaker is connected (In this kind of situation, [ERR] is displayed for all surround and surround back speakers.) An error is indicated in addition to the above if the speakers are connected as follows. • When using just one surround back speaker, but it is connected to the surround back R-channel (To use just one surround back speaker, connect it to the Lchannel.) • Check the speaker that is indicated as having reversed polarity ([REV] can appear with some speakers even when properly connected. In such case, ignore the error indication.) • Check speaker direction and layout 48