Maytag MDB7609AWB Installation Instructions - Page 10

Option B, No waste disposer - no air gap Option D, No waste disposer - with air gap i: i 1. Connect black end of of drain hose to waste tee and cut if needed. (Do not cut ribbed section.) 2. Attach black end of drain hose to waste tee with a large silver drain hose clamp (provided). Use pliers to squeeze clamp open and move into position. If the drain hose was cut, use a 1 1/2" to 2" (3.8 to 5 cm) screw-type clamp (not provided). Option C, Waste disposer - with air gap Drain trap 1. Using a hammer and screwdriver, knock plug into disposer. 2. Use needle nose pliers to remove plug. 3. Connect black end of drain hose to air gap and cut if needed. (Do not cut ribbed section.) 4, Attach drain hose to air gap with large silver drain hose clamp (provided). Use pliers to squeeze clamp open and move into position. If the drain hose was cut, use a 1 1/2" to 2" (3.8 to 5 cm) screw-type clamp (not provided). 5, Use a rubber hose (not provided) with screw-type clamps (not provided) to connect from air gap to disposer inlet. 10 Connect black end of drain hose to air gap and cut if needed. (Do not cut ribbed section.) 2, Attach drain hose to air gap with large silver drain hose clamp (provided). Use pliers to squeeze clamp open and move into position. If the drain hose was cut, use a 1 1/2" to 2" (3.8 to 5 cm) screw-type clamp (not provided). 3, Use a rubber hose (not provided) with screw-type clamps (not provided) to connect from waste tee to air gap. Install moisture barrier (on some models) I Moisture barrier 1. Make sure the area under the cabinet is clean and dry for installation of the moisture barrier. 2. Remove the backing of the moisture barrier and apply to underside of the countertop along the front edge of the counter.