Maytag MDB7609AWB Installation Instructions - Page 9

Slowlyroutewatersupplylinethroughholein cabinet. (If usingcoppetrubing,itwill bendandkinkeasilys,obe tgoecnotlnen.I)et sciht tooutlhdbeedfiasrhewnaosuhgeihnirnletottohnethcaebfrionnetotlepfetning sideof thedishwasher. Route drain hose as shown through hole in cabinet to the front center of opening where drain connection will be made. Tape drain hose to the floor in area shown. This will prohibit it from moving when dishwasher is moved into cabinet opening. Slowlyturnwatershutoffvalveto "ON"positionF. lush waterintoashallowpanuntilclearto getrid of particles thatcouldclogtheinletvalveT. urnshutoffvalveto "OFF"position. Install Drain Hose IMPORTANT: Always use a new drain hose. Check local codes to determine if an air gap is required. , Option B, No waste disposer- no air gap 'Option C; Waste disPOser _with air gap Option D, No Waste disposer _ With air gap IMPORTANT: The drain hose connection of the disposer or a waste tee must be made before the drain trap and at least 20" (50.8 cm) above the floor where the dishwasher will be installed. Helpful "lip: To reduce vibration of the hose, keep the hose away from the floor. Option A, Waste disposer - no air gap ....Drai 1. Using a hammer and screwdriver, knock plug into disposer. 2. Use needle nose pliers to remove plug. If needed, drill a 1 1/2" (3.8 cm) diameter hole in cabinet wall or side of the opening closest to the sink. 3. Attach drain hose to disposer inlet with large silver drain hose clamp (provided). Use pliers to squeeze clamp open and move into position.