Netgear GSM7252PS 7000 Series Managed Switch Administration Guide for Software - Page 125

ProSafe 7000 Managed Switch Software Administration Manual, Release 8.0.3 Configure VRRP on a Master Router This example shows how to configure the 7000 Series Managed Switch to support VRRP. Router 1 will be the default master router for the virtual route, and Router 2 will be the backup router. CLI: Configuring VRRP on a Master Router The following is an example of configuring VRRP on a 7000 Series Managed Switch acting as the master router: Enable routing for the switch. IP forwarding will then be enabled by default. (Netgear Switch) #config (Netgear Switch) (Config)#ip routing Configure the IP addresses and subnet masks for the port that will participate in the protocol. (Netgear Switch) (Config)#interface 1/0/2 (Netgear Switch) (Interface 1/0/2)#routing (Netgear Switch) (Interface 1/0/2)#ip address 192.150.2.1 255.255.0.0 (Netgear Switch) (Interface 1/0/2)#exit Enable VRRP for the switch. (Netgear Switch) (Config)#ip vrrp Assign virtual router IDs to the port that will participate in the protocol. (Netgear Switch) (Config)#interface 1/0/2 (Netgear Switch) (Interface 1/0/2)#ip vrrp 20 Specify the IP address that the virtual router function will recognize. Note that the virtual IP address on port 1/0/2 is the same as the port's actual IP address, therefore this router will always be the VRRP master when it is active. And the priority default is 255. (Netgear Switch) (Interface 1/0/2)#ip vrrp 20 ip 192.150.2.1 8-2 Virtual Router Redundancy Protocol v1.0, June 2010