Netgear GSM7252PS 7000 Series Managed Switch Administration Guide for Software - Page 56

ProSafe 7000 Managed Switch Software Administration Manual, Release 8.0.3 The diagram in this section shows a Layer 3 switch configured for port routing. It connects two VLANs, with two ports participating in one VLAN, and one port in the other. The script shows the commands you would use to configure a 7000 Series Managed Switch to provide the VLAN routing support shown in the diagram. Layer 3 Switch Port 1/0/2 VLAN Router Port 1/3/1 192.150.3.1 Port 1/0/3 VLAN Router Port 1/3/2 192.150.4.1 Port 1/0/1 Layer 2 Switch Layer 2 Switch VLAN 10 VLAN 20 Figure 4-1 CLI: Creating Two VLANs The following code sequence shows an example of creating two VLANs with egress frame tagging enabled. (Netgear Switch) #vlan data (Netgear Switch) (Vlan)#vlan 10 (Netgear Switch) (Vlan)#vlan 20 (Netgear Switch) (Vlan)#exit (Netgear Switch) #conf (Netgear Switch) (Config)#interface range 1/0/1-1/0/2 (Netgear Switch) (conf-if-range-1/0/1-1/0/2)#vlan participation include 10 (Netgear Switch) (conf-if-range-1/0/1-1/0/2)#vlan pvid 10 (Netgear Switch) (conf-if-range-1/0/1-1/0/2)#exit (Netgear Switch) (Config)#interface 1/0/3 (Netgear Switch) (Interface 1/0/3)#vlan participation include 20 (Netgear Switch) (Interface 1/0/3)#vlan pvid 20 (Netgear Switch) (Interface 1/0/3)#exit (Netgear Switch) (Config)#exit VLAN Routing 4-2 v1.0, June 2010