Netgear GSM7252PS 7000 Series Managed Switch Administration Guide for Software - Page 396
Enable a Double VLAN, CLI: Enabling a Double VLAN on a VLAN
UPC - 606449071665
View all Netgear GSM7252PS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 396 highlights
ProSafe 7000 Managed Switch Software Administration Manual, Release 8.0.3 Enable a Double VLAN The following example shows how to configure the switch (the NETGEAR switch) in the preceding figure to add a double VLAN tag for traffic going from the subnet domain connected to port 1/0/24. This example assumes there is a layer 2 switch connecting all these devices in your domain. The layer 2 switch tags the packet going to the NETGEAR switch port 1/0/24. The example is shown as CLI commands and as a Web interface procedure. The two NETGEAR switches have the same configuration. CLI: Enabling a Double VLAN on a VLAN Create a VLAN 200. (Netgear Switch)#vlan database (Netgear Switch) (Vlan)#vlan 200 (Netgear Switch) (Vlan)#exit Add interface 1/0/24 to VLAN 200, add pvid 200 to the port. (Netgear Switch) #config (Netgear Switch) (Config)#interface 1/0/24 (Netgear Switch) (Interface 1/0/24)#vlan pvid 200 (Netgear Switch) (Interface 1/0/24)#vlan participation include 200 (Netgear Switch) (Interface 1/0/24)#exit Add interface 1/0/48 to the VLAN 200 in a tagging mode. (Netgear Switch) (Config)#interface 1/0/48 (Netgear Switch) (Interface 1/0/48)#vlan participation include 200 (Netgear Switch) (Interface 1/0/48)#vlan tagging 200 (Netgear Switch) (Interface 1/0/48)#exit Select interface 1/0/48 as the provider port. (Netgear Switch) (Config)# (Netgear Switch) (Config)#interface 1/0/48 (Netgear Switch) (Interface 1/0/48)#mode dvlan-tunnel (Netgear Switch) (Interface 1/0/48)#exit Web Interface: Enabling a Double VLAN on a VLAN To use the Web Interface to enable a double VLAN on a VLAN, proceed as follows: 1. Create static VLAN 200: Double VLANs v1.0, June 2010 21-2