Netgear GSM7252PS 7000 Series Managed Switch Administration Guide for Software - Page 415
On GSM7328S_2, This example is using 6in4 mode. If you want to use 6to4 mode
UPC - 606449071665
View all Netgear GSM7252PS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 415 highlights
ProSafe 7000 Managed Switch Software Administration Manual, Release 8.0.3 (Netgear Switch) (Config)#interface tunnel 0 (Netgear Switch) (Interface tunnel 0)#ipv6 enable (Netgear Switch) (Interface tunnel 0)#ipv6 address 2000::1/64 (Netgear Switch) (Interface tunnel 0)#tunnel mode ipv6ip (Netgear Switch) (Interface tunnel 0)#tunnel source 192.168.1.1 (Netgear Switch) (Interface tunnel 0)#tunnel destination 192.1.168.1.2 (Netgear Switch) (Interface tunnel 0)#exit (Netgear Switch) (Config)#exit Note: This example is using 6in4 mode. If you want to use 6to4 mode, please configure each unit as below and be sure the prefix length is 16. interface tunnel 0 tunnel mode ipv6ip 6to4 tunnel source 4.4.4.1 ipv6 enable ipv6 address 2002:404:401::1/16 exit (Netgear Switch) #show interfacet tunnel 0 Interface Link Status Up IPv6 is enabled IPv6 Prefix is FE80::C0A8:101/128 2000::1/64 MTU size 1280 bytes #show interface tunnel TunnelId Interface TunnelMode SourceAddress DestinationAddress 0 tunnel 0 6 in 4 Configured 192.168.1.1 192.168.1.2 (Netgear Switch) # ping ipv6 2000::2 Send count=3, Receive count=3 from 2000::2 Average round trip time = 1.00 ms On GSM7328S_2 (Netgear Switch) #config (Netgear Switch) (Config)#ip routing (Netgear Switch) (Config)#ipv6 forwarding (Netgear Switch) (Config)#ipv6 unicast-routing (Netgear Switch) (Config)#interface 1/0/13 (Netgear Switch) (Interface 1/0/13)#routing (Netgear Switch) (Interface 1/0/13)#ip address 192.168.1.2 255.255.255.0 (Netgear Switch) (Interface 1/0/13)#exit 24-2 v1.0, June 2010 Tunnel